Give your RV awning a fresh start without replacing the entire assembly. The Lippert V000334393 is a made-to-order 13.5-oz vinyl replacement fabric sized at 14'1" wide with an 8-foot projection -- designed specifically to fit 15-foot Solera, Dometic, and Carefree awning systems. Cold-crack tested to -25F and built with heat-welded seams, this fabric is engineered for long-term outdoor durability across all four seasons.
When your existing awning fabric fades, tears, or develops leaks, swapping the fabric is a cost-effective alternative to replacing the full awning arm assembly. The V000334393 drops directly into 15-foot Solera, Dometic, and Carefree roller assemblies -- no modification needed when ordering the correct size for your rig.
The Silver Fade colorway presents a gradient exterior finish with a clean white underside, which reflects heat and keeps your outdoor living space cooler. The poly cord sewn into the lead rail hem accommodates an optional aftermarket LED light track -- lights and the light track itself are sold separately.
Heavy-duty vinyl fabric resists tearing, UV degradation, and moisture. Rated for extended outdoor exposure in both sun and rain.
Seams are bonded under heat and pressure rather than stitched, eliminating needle holes that can admit water and weaken fabric over time.
Vinyl remains flexible and crack-resistant in sub-zero temperatures -- critical for four-season campers and winter storage in cold climates.
Engineered to fit Solera, Dometic, and Carefree awning roller assemblies in the 15-foot size class without adapters or modifications.
Awning fabric width is measured across the rolled fabric, not the full span of your awning arms. For a 15-foot awning assembly, the correct replacement fabric measures approximately 14 feet 1 inch wide -- roughly 11 inches shorter than the arm-to-arm measurement. This gap accounts for the end caps and hardware on each side of the roller tube.
This fabric offers an 8-foot projection from the side of your RV to the lead rail. That span provides substantial shade coverage over a standard patio setup, protecting seating areas, camp tables, and entry steps from direct sun and light rain.
A poly cord is factory-sewn into the hem of the lead rail pocket. This cord serves as a pull-through anchor for compatible aftermarket LED awning light tracks that clip or slide into the hem channel.
Replacement awning fabric installation on Solera, Dometic, and Carefree systems follows a similar process: remove the end caps from the roller tube, slide out the old fabric, thread the new fabric's bolt rope into the roller tube groove, and reseat the end caps. The lead rail rope feeds into the awning arms in the same way.