Give your RV awning a fresh start without replacing the entire assembly. The Lippert V000334399 is a factory-quality 13.5-oz vinyl replacement fabric designed for 16 ft awning setups using Solera, Dometic, or Carefree hardware. At 15'1" wide with an 8 ft projection, it delivers serious shade coverage -- backed by heat-welded seams and cold-crack resistance down to -25F.
Awning fabric takes a beating -- UV exposure, wind stress, rain pooling, and repeated rolling cycles all degrade cheaper materials over time. Lippert's Solera replacement fabric is made from 13.5-oz vinyl, a heavier weight than many aftermarket options, giving it the durability and drape that matches original equipment performance.
The Sand Fade colorway is a warm, neutral gradient that blends naturally with most RV exterior palettes. The underside is finished in white, which reflects heat back upward and keeps the shaded area noticeably cooler on hot days.
Heavier-weight vinyl resists tearing, UV degradation, and surface cracking better than lighter fabrics. Built to withstand repeated seasonal use.
Seams are thermally bonded rather than sewn, eliminating needle holes that can allow water infiltration. Critical stress points are reinforced at the weld.
Vinyl can become brittle in extreme cold. This fabric is tested to remain flexible and crack-resistant down to -25F -- important for four-season and northern RV use.
Includes a poly cord sewn into the valance hem for optional aftermarket LED light track installation. Light track and LED lights are not included.
This fabric is sized for a 16 ft awning assembly. The fabric width of 15'1" is intentional -- replacement fabrics are typically cut approximately 11 inches shorter than the nominal awning assembly width to allow proper tensioning when installed on the roller tube. Do not order based on awning assembly width alone; measure your existing fabric or consult your awning's installation specs.
The fabric projects 8 feet out from the RV wall when fully extended, providing substantial shade coverage for slideouts, entry doors, and patio seating areas.
Sand Fade is a gradient pattern that transitions through warm sandy tones. The exterior-facing surface carries the Sand Fade print; the interior (underside) is solid white. Screen-printed colors may vary slightly from digital representations -- if color matching is critical, request a swatch sample before ordering.