Keep dirt, leaves, rain, and debris off your RV slide-out roof with the Lippert Solera Slide Topper. This permanently attached awning extends and retracts with your slide-out automatically -- no manual setup required. The heated wedge-welded seams and black vinyl fabric deliver durable, leak-resistant protection that holds up mile after mile.
Slide-out rooms are one of the most expensive components on any RV. Debris that piles up on a slide-out roof can work its way into seals, scratch painted surfaces, and cause premature seal failure -- repairs that easily run into hundreds of dollars. The Lippert Solera Slide Topper mounts directly above the slide opening and rolls out automatically whenever the room extends, then retracts cleanly when the room comes back in.
This specific listing is for the 9 ft 1 in (109") fabric length, Part Number V000168325 (SKU 00-0489, UPC 848150015563). It is sized for RV slide-outs with a flange-to-flange width of 104" to 109" and a slide length up to 114" with up to 48" of extension. If your slide measurements fall outside that range, a different size is required -- see fitment details in the spec tables.
Factory seams are bonded with a heated wedge process for a leak-resistant joint -- no stitching to wick water into your slide-out roof area.
Permanently attached to the slide-out. No manual intervention needed -- the topper rolls out and back in every time the room moves.
Heavy-duty black vinyl resists scuffs, mildew, and UV degradation. The matching black casting maintains a clean, factory-style appearance on the rig.
Ships with mounting rail and all required hardware for installation. No sourcing separate fasteners or rails for a standard fit.
When a slide-out is retracted, anything sitting on its roof -- pine needles, acorns, standing water, bird debris -- gets dragged across the slide seal and potentially into the interior. Over a season of camping, that accumulation accelerates seal wear and can void roof warranties. The Solera Slide Topper acts as a barrier layer: debris that lands on the topper fabric simply rolls off or is contained in the rolled tube rather than being pulled inside.
The Solera Slide Topper mounts to the exterior sidewall of the RV directly above the slide-out opening using the included mounting rail. The opposite end of the fabric attaches to the slide-out room itself so the awning travels with the room. Installation requires basic hand tools and two people for safe handling of the rail assembly.