Full all-season protection for 32 to 35 foot Class C motorhomes. The PolyPRO 3 Deluxe uses a triple-ply polypropylene top panel and breathable single-ply sides to shield your rig from rain, snow, UV, dirt, and road debris -- without trapping the moisture that causes mold and mildew.
Class C RVs present a unique challenge for cover manufacturers -- the cab-over bunk section creates an irregular roofline that generic covers never quite fit. Classic Accessories engineered the PolyPRO 3 Deluxe specifically for this body style, with elasticized hem corners and adjustable front and rear tension panels that conform to the contours of the cab-over nose and the rear overhang.
The result is a cover that stays put in wind, doesn't pool water, and won't abrade your RV's finish during seasonal storage. At 125 inches of roof-to-ground height clearance, this cover accommodates the taller cab-over profile common on Class C rigs in the 32 to 35 foot range.
The roof section uses thick triple-ply PolyPRO 3 fabric to handle rain, snow loads, UV rays, and falling debris -- the areas that take the most punishment in storage.
Quick-drying PolyPRO 1 side panels reduce wind stress and allow interior moisture to vent outward, preventing mold and mildew buildup under the cover.
An integrated rope attachment system and included toss bag let you thread the cover under the RV from one side without crawling -- a real time-saver when covering solo.
Zippered panels on the front and sides allow access to entry doors and the engine compartment area so you can check on the rig without removing the entire cover.
This cover is sized for Class C motorhomes with a body length between 32 and 35 feet. The 125-inch roof-to-ground height accommodates the cab-over bunk overhang typical of Class C chassis. If your rig is near the top of the range, measure your actual height before ordering -- some high-roof Class C units may exceed the 125-inch clearance.
Adjustable tension panels at the front and rear allow you to cinch the cover down firmly once it is in place. Elasticized hem corners grip the lower body panels and help prevent wind from lifting the cover during storage. For extended outdoor storage in high-wind areas, additional tie-down straps (sold separately) are recommended along the lower hem.
The PolyPRO 3 material is a non-woven polypropylene fabric. It is not waterproof in the traditional sense -- it is water-resistant and breathable, which is intentional. A fully waterproof cover traps condensation against the RV surface and promotes mildew. The PolyPRO construction sheds rain and blocks UV while letting vapor pass through the fabric before it accumulates.
The cover ships with a carrier bag for off-season or off-cover storage. The bag keeps the cover compact and protected when not in use. Classic Accessories backs the PolyPRO 3 Deluxe with a limited 3-year manufacturer warranty against defects in materials and workmanship.