Designed specifically for Class B motorhomes and camper vans in the 20 to 23 foot range, the Classic Accessories PolyPRO3 Model 2 cover delivers all-season protection with a triple-ply reinforced top and breathable PolyPRO sides. Whether you are storing your rig through a harsh winter or shielding it from summer UV rays and bird droppings, this cover is built to stay put, breathe properly, and give you easy access without a full removal.
Class B vans and camper vans face unique storage challenges -- compact footprint but tall rooflines, side-entry doors that need to stay accessible, and the constant threat of condensation buildup under a sealed cover. The PolyPRO3 Model 2 addresses all of that with a purpose-built construction that layers heavy-duty protection on top where weather hits hardest and breathable fabric on the sides where moisture needs to escape.
At 18 lbs, this is a substantial cover, but Classic Accessories engineered it for solo installation. The integrated rope attachment system and included toss bag let you run securing straps under the vehicle without crawling on the ground. Adjustable tension panels front and rear, plus elasticized hem corners, pull the cover snug against your rig for a fitted look that does not flap loose in the wind.
Three-layer construction on the roof panel resists rain, snow, UV degradation, and impact from tree debris. Significantly thicker than single-ply covers in this class.
Single-ply breathable side panels allow trapped moisture and condensation to vent out, preventing mildew and paint damage during long-term storage.
Zippered openings let you access RV entry doors and engine compartments without removing the entire cover -- a practical feature for partial-storage or maintenance periods.
Built-in air vents reduce wind stress by relieving pressure buildup under the cover, helping the cover stay in place during high-wind storage conditions.
This Model 2 cover is sized for Class B vehicles up to 23 feet in length, with a maximum height of 117 inches (9 ft 9 in) and a maximum width of 84 inches (7 ft). Verify your rig's length, height, and width before ordering -- Class B vans with roof racks, pop-tops, or rooftop AC units may push past the height limit.
Sizing tip: Measure your van at its tallest point, including any rooftop accessories. The 117-inch max height accommodates most factory Class B builds but may not clear aftermarket high-roof conversions or rooftop AC units on taller platforms.
Classic Accessories designed this cover for practical solo installs. The toss bag lets you throw the securing rope under the vehicle and retrieve it from the other side -- no more lying on pavement to fish a cord. Once the cover is draped, adjustable front and rear tension panels cinch the cover lengthwise, while the elasticized hem corners lock each corner down against the vehicle's lower body.
What's included: PolyPRO3 cover, stuff sack for storage, toss bag for installation, and ladder caps (included on most models in this series). No additional hardware or straps required for basic installation.
Coverage note: This cover is rated for moderate weather conditions. It is not designed as a primary defense against severe hail, extreme sustained winds, or falling branches. For extreme climates, consider supplemental tie-down straps or covered storage.
This cover is backed by a limited 3-year manufacturer warranty from Classic Accessories covering defects in materials and workmanship under normal use and storage conditions.