Replacement back cover for a Solera Regal awning head assembly, shielding the internal drive and idler components from dirt, debris, and everyday wear. Universal fit across Solera's power and manual Regal awning lineup.
The Lippert 643921 is a replacement back cover for the head assembly on a Solera Regal awning, fitting both the drive end and idler end. It shields the internal components at the rear of the head assembly from dirt, debris, and other environmental wear, helping extend the life of your awning's mechanism.
This cover is universal across all Solera power and manual Regal head assemblies, including short, flat, and pitched styles, and installs with no assembly required — just remove the old cover and screw the new one into place.
Shields internal components from dirt and debris
Works with short, flat, and pitched head assemblies
Same cover works on either end of the head assembly
Simple screw-on replacement, ready to install
This is a Solera Regal awning head assembly back cover — it is not a slide-out cover or slide-out component. If you're looking for a part for a slide-out room, this is not the correct cover.
In The Box: • One (1) Regal Head Assembly Back Cover