Home > Home & Marine Upgrades > Blower Motors >

Packard 66758 Replacement Carrier Draft Inducer Blower Motor 115V 3400 RPM PSC 58W

Packard 66758 replacement Carrier draft inducer blower motor, 115V 3400 RPM 58-watt PSC with ball bearing and 3-prong Molex plug
Packard Replacement Carrier Draft Inducer Blower Motor, 115V, 3400 RPM
 
List Price: $299.99
: $214.49
You save $85.50!
Part Number: 66758
Manufacturer: Packard

Quantity in Stock :38

Free Shipping
Availability: In Stock
Qty:

 
Packard115V / 3400 RPMCapacitor IncludedPackard 66758 -- Replacement Carrier Draft Inducer Blower Motor

A direct-fit replacement for select Carrier furnace draft inducer assemblies. The Packard 66758 is a 58-watt PSC motor running at 115V and 3400 RPM, built with ball bearings and automatic overload protection. Capacitor and 3-prong Molex plug are included -- no scrounging for extra parts before installation.

Direct Replacement for Carrier Draft Inducer Motors

The draft inducer motor is the workhorse that pulls combustion gases through your furnace heat exchanger and vents them safely out of the flue before the main burner ignites. When this motor fails, the furnace locks out entirely -- no heat until it is replaced. The Packard 66758 is engineered to restore factory performance without custom wiring or bracket modifications.

This motor cross-references directly to the OEM Carrier part numbers listed below and slots into the same inducer housing using the existing mounting hardware. The pre-wired 3-prong Molex connector matches the factory harness, and the included capacitor means you have everything needed to complete the swap.

PSC Motor Design

Permanent Split Capacitor (PSC) motor provides efficient, reliable single-speed operation at 3400 RPM. Capacitor is included in the box -- no separate purchase needed.

Ball Bearing Construction

Ball bearings instead of sleeve bearings for longer service life, lower heat buildup, and quieter operation over extended heating seasons.

Automatic Overload Protection

Internal thermal overload protector shuts the motor down if it exceeds safe operating temperature, protecting your furnace control board from cascading failures.

Molex Plug Ready

3-prong Molex plug is pre-installed and matches the OEM Carrier harness connector. Plug-and-play installation -- no splicing or crimping required.

OEM Cross-Reference -- Carrier Part Numbers Replaced

The Packard 66758 (also sold as NBK Parts 20290) is a confirmed replacement for the following OEM and aftermarket part numbers:

  • Carrier 050L22541-01
  • Carrier 320725758
  • Carrier HC28CQ115
  • Carrier YDZ-050L22541-01
  • Broad-Ocean Motor Co. YDZ-050L22541-01
  • AllTemp FB-RFB758
  • Rotom FB-RFB758
Capacitor Included: Many aftermarket inducer motors are sold motor-only, requiring a separate capacitor order. The 66758 includes the capacitor, so your furnace is back up in one trip.

Installation Notes

Before ordering, confirm your existing inducer assembly uses one of the OEM part numbers listed above, or visually verify the motor nameplate reads 115V / 60Hz / 3400 RPM / 1.45A. The Molex connector and motor frame are matched to the Carrier housing -- forcing this motor into a non-compatible assembly risks damage.

Class B Insulation: Class B insulation rating (up to 130 deg C / 266 deg F winding temperature) is appropriate for standard residential and light-commercial gas furnace draft inducer duty cycles.
Maintenance Tip: When replacing the inducer motor, inspect the inducer wheel (squirrel cage) for cracks, carbon deposits, or wobble. A worn wheel on a new motor shortens motor life and can cause noise or reduced draft. Replace the wheel if worn.
Single Speed Only: This is a single-speed motor. It is not compatible with furnace control boards that expect a variable-speed or two-speed inducer signal.

Electrical Specifications

Voltage115V AC
Frequency60 Hz
Amperage1.45A
Wattage58 watts
Speed3400 RPM (single speed)
Motor TypePSC (Permanent Split Capacitor)

Motor Construction

Bearing TypeBall bearing
Insulation ClassClass B
Overload ProtectionAutomatic thermal overload
Connector3-prong Molex plug (pre-installed)

Physical

Weight6 lbs

What's in the Box

MotorPackard 66758 PSC inducer motor
CapacitorIncluded
Connector3-prong Molex plug (factory-installed on motor leads)

Part Number Cross-Reference

Packard Part #66758
NBK Parts #20290
Carrier OEM #050L22541-01
Carrier OEM #320725758
Carrier OEM #HC28CQ115
Carrier OEM #YDZ-050L22541-01
Rotom #FB-RFB758
AllTemp #FB-RFB758
Broad-Ocean #YDZ-050L22541-01
Important Information
  • Always disconnect power to the furnace at the breaker before removing or installing any motor or electrical component.
  • Verify your existing motor nameplate matches 115V / 60Hz / 3400 RPM / 1.45A before installing. Installing a mismatched motor can damage the furnace control board.
  • This is a single-speed PSC motor -- not compatible with furnaces requiring variable-speed or two-speed inducer control.
  • The capacitor is included, but inspect the existing inducer wheel before reassembly. A cracked or out-of-balance wheel will shorten the new motor's lifespan.
  • Confirm OEM part number on your existing motor label against the cross-reference list above. Carrier model numbers alone are not sufficient to confirm fitment across all production runs.


Browse for more RV Accessories in the same category as this item:

Home & Marine Upgrades > Blower Motors
Home & Marine Upgrades


$316.05
$30.49