When you're pulling a loaded travel trailer, fifth-wheel toter, or boat rig down a mountain grade, your hitch ball is not the place to cut corners. B&W Hitches builds the HB94007 from precision-forged steel -- the same brand trusted by serious RVers and truck owners who demand components that hold up mile after mile, season after season. Swap a worn or undersized ball for a purpose-built B&W unit and tow with confidence.
B&W Hitches has been manufacturing towing components in Humboldt, Kansas since 1987. Every hitch ball that leaves their facility is held to tight dimensional tolerances so your coupler seats cleanly, latches fully, and stays locked under dynamic load -- whether you're on an interstate slab or a washboard forest service road.
The HB94007 is a solid forged-steel ball designed to deliver the precise shank diameter, ball diameter, and thread engagement that Class III and Class IV couplers demand. At 5.35 lbs, this is a substantial, full-material ball -- not a hollow or lightweight casting.
Hot-forged from high-strength steel for superior grain structure and impact resistance compared to cast alternatives.
CNC-machined shank and ball surface ensure accurate fit into receiver-mounted ball mounts and proper coupler engagement.
Chrome or zinc-plated finish protects against road salt, moisture, and UV exposure through years of outdoor use.
Made in the USA by B&W Hitches -- a manufacturer whose components are standard equipment on some OEM truck hitches.
The HB94007 is designed for use with standard 2-inch ball-mount receivers and compatible coupler sizes common to travel trailers, cargo trailers, boat trailers, and utility trailers in the Class III and Class IV weight ranges. It pairs directly with B&W ball mounts and is dimensionally compatible with most aftermarket and OEM receiver-style ball mount plates that share the same shank-hole diameter and thread specification.
Confirm your coupler's ball diameter requirement before installing. Common trailer coupler ball sizes are 1-7/8 inch, 2 inch, and 2-5/16 inch -- match this ball's diameter to your coupler's stamped specification for safe towing.
Thread the HB94007 into your ball mount plate by hand first to confirm thread engagement, then torque the retaining nut to the specification printed on the ball or ball mount -- typically 150 to 300 ft-lbs for 1-1/4 inch shank balls and higher for larger shanks. Under-torqued balls can rotate or back off under dynamic load.