A drooping sewer hose that pools waste mid-run is more than a nuisance -- it is a sanitation problem. The Lippert 2025022183 sewer hose support holds your 3-inch RV drain line at a consistent downward slope so gravity does the work every time you dump. The adjustable, accordion-style nesting segments collapse flat for storage and extend to cover a full 10 feet of hose, making it the right pick for most campsite hookup distances.
Nobody wants a sewer hose lying flat on the ground collecting dirt, insects, and campsite runoff between hookup and RV. This Lippert support cradles your hose in individual segment slots and lets you angle the whole run so waste flows consistently toward the dump station -- no backpressure, no pooling, no mess left in the hose after you disconnect.
The accordion design means each segment nests inside the next for storage. The entire support packs down to a compact bundle that slips easily into a bumper storage tube or an exterior bay alongside your sewer kit. At 3.3 lbs shipped, it adds minimal weight to your kit.
Extends to 10 feet to bridge the gap between your RV's waste outlet and the campsite dump connection. Works solo or paired with a second support for longer runs.
Individual support legs vary in height across the run, creating a built-in downhill angle that moves waste efficiently and empties the hose completely after each dump.
Segments collapse into each other for compact storage. No loose parts to lose. The whole support assembles and disassembles without tools in under a minute.
Cradle slots fit the standard 3-inch diameter sewer hoses used on virtually every Class A, Class C, fifth wheel, and travel trailer on the market today.
If your campsite hookup is more than a few feet from your RV's waste outlet -- which is most full-hookup sites -- a sewer hose support is a practical requirement, not a luxury. Many campgrounds actually require that hoses be kept off the ground as part of their sanitation standards. The Lippert support satisfies that requirement and makes your dump routine noticeably cleaner.
Full-timers who dump frequently will especially appreciate the slope design. A properly elevated hose empties almost completely on its own, which reduces odor and keeps the inside of the hose cleaner between uses.
Got a 20-foot sewer hose run? Use two of these supports end-to-end. Each unit handles 10 feet, and the heights are graduated so you can maintain a continuous slope across both units without creating a flat or low spot in the middle.
This support is designed around the standard 3-inch RV sewer hose -- the same diameter used by Camco Rhino hoses, Valterra Dominator hoses, and virtually every OEM sewer kit shipped with travel trailers, fifth wheels, Class A motorhomes, and Class C motorhomes. If your hose uses standard RV bayonet fittings (3-inch), this support will cradle it correctly.
The collapsed support measures approximately 10.43 x 7.68 x 6.69 inches -- sized to fit in most RV bumper storage tubes and exterior bays alongside your sewer hose kit. Store it in a dedicated zip bag to keep it separate from your clean-side gear.
Unfold the segments from their nested position and set the support on the ground under your sewer hose run. The tallest end goes under the hose near your RV outlet; the lowest end points toward the dump connection. Lay your hose into the cradle slots, connect both ends, and you are ready to dump. No assembly tools required, no hardware to tighten.