Keep your electric coach steps cycling smoothly with this direct-replacement bronze bushing from Lippert. Engineered with a self-lubricating sintered bronze construction, it installs into the step joint assembly without any grease or ongoing maintenance -- restoring the quiet, reliable extension and retraction your steps depend on.
Over time, the plastic or worn bronze bushings inside electric coach step pivot joints develop play and friction. A degraded bushing causes the step to bind, grind, or wobble during travel and deployment. Replacing the bushing is a straightforward repair that restores proper alignment and extends the life of the entire step mechanism.
Lippert part 116531 is the OEM-spec replacement bushing for the pivot and slide joints found in Lippert-branded single, double, and triple electric coach steps, as well as compatible Stromberg Carlson sliding step assemblies. At just 0.05 lbs, it ships light but handles the repetitive load cycling of daily RV entry and exit without requiring re-lubrication.
Sintered bronze construction holds lubricant within the material matrix -- no grease fittings, no spray lube, no maintenance intervals to track.
Dimensioned to OEM spec (1/2" OD x 3/8" ID x 5/16" length) for drop-in replacement in Lippert and Stromberg Carlson step joint assemblies.
Restores tight pivot tolerances, eliminating the clunking and wobble caused by a worn or collapsed bushing in the step linkage.
Backed by Lippert's limited 1-year manufacturer warranty for added peace of mind on a critical step component.
This bushing is designed for use in the following step platforms:
Inspect your step bushings if you notice any of the following:
This bushing replaces the existing bushing inside the step joint assembly. Installation typically involves removing the step from the coach, disassembling the pivot joint, pressing out the old bushing, and pressing or tapping the new bushing into place. A bench vise or bushing driver tool makes installation easier and prevents damage to the bore.