When your campsite pedestal is just out of reach, the Camco Power Grip extension cord gives you a full 25 feet of heavy-duty 10 AWG power delivery rated for 30-amp RV service. Bright yellow ergonomic pull handles on both ends make plugging and unplugging at tight pedestals easier and safer -- no more wrestling with a slippery plug in the rain. CSA certified for indoor and outdoor use.
Campground pedestals are not always conveniently located next to your rig. A 25-foot, 30-amp-rated extension cord lets you set up comfortably at pull-through sites, back-in sites with offset pedestals, or temporary setups where a short cord just doesn't make it. Camco's Power Grip design addresses the most common frustration with RV extension cords: the plugs are hard to grip and remove, especially when the pedestal is low to the ground or your hands are wet.
This cord uses the standard TT-30P male plug and TT-30R female socket -- the connectors found on virtually every 30-amp RV shore power outlet in North America. It will not fit a standard 15- or 20-amp household wall outlet. A carrying strap is included so you can store the cord coiled without it tangling in your basement compartment.
Large yellow overmolded pull handles on both the TT-30P plug and TT-30R socket let you unplug with a firm grip -- no pinched fingers on a cold morning.
10 AWG copper conductors handle the full 30-amp load with minimal voltage drop across 25 feet -- keeping your AC, microwave, and water heater running at spec.
Three-prong TT-30 connectors are polarized and grounded for proper equipment protection and compatibility with GFCI-equipped pedestals.
Black thermoplastic jacket stands up to UV exposure, oil, and abrasion at campgrounds. CSA certified for both indoor and outdoor environments.
The TT-30P (male) and TT-30R (female) are the dedicated 30-amp RV connector standard. They are not interchangeable with standard household NEMA 5-15 or 5-20 outlets. If your rig runs on 30-amp shore power, this is the correct cord family. If you need to connect to a 50-amp pedestal or a standard household outlet, you will need a separate adapter -- this cord does not include adapters.
The included carrying strap keeps the cord coiled and contained between trips. At 7.8 lbs for a 25-foot, 10 AWG cord, this is about the expected weight for a properly built 30-amp extension -- lighter cords at this length are almost always a sign of undersized wire.
Camco backs this cord with a limited 90-day manufacturer warranty against defects in materials and workmanship. The cord carries CSA (Canadian Standards Association) certification, confirming it meets published safety standards for electrical cords used in recreational vehicle applications.