The indoor half of your Furrion Chill system. This low-profile ceiling assembly pairs with the Chill, Chill HE, and Chill Cube rooftop units (R32 refrigerant, 2025 and newer) to deliver quiet, controlled airflow inside your RV -- no app or thermostat required. Manual recessed knobs handle fan speed and temperature directly at the unit.
If you are running a Furrion Chill, Chill HE, or Chill Cube rooftop AC on an R32 refrigerant platform (2025+), this is the matching interior ceiling assembly. It mounts in your RV ceiling opening and handles air intake, filtration, and conditioned air distribution back into the cabin -- all from a slim, unobtrusive housing.
Manual operation means straightforward, reliable control with no touchscreen or connectivity dependency. Two recessed knobs on the face of the unit adjust fan speed and temperature setpoint. The closeable shutter lets you block airflow entirely when the AC is off, preventing drafts and heat loss.
Two built-in knobs for fan speed and temperature -- no thermostat wiring or app pairing needed.
Seal the ceiling opening when the AC is off to block drafts, insects, and heat transfer.
Tool-free filter removal for cleaning or replacement. Keeps airflow efficient and extends system life.
Compatible with both ducted distribution systems and standard non-ducted single-zone installs.
The FACT11CA2-PS-AM is the interior ceiling assembly only. It does not include the rooftop condenser/evaporator unit, refrigerant lines, or any electrical wiring harness. It is the air distribution box that sits inside the RV, visible from the ceiling, and connects to the rooftop Chill unit above.
This model features manual control knobs, not a digital display or remote receiver. If you need thermostat-based or app-based control, Furrion offers alternate ceiling assembly variants for the Chill platform -- confirm your control preference before ordering.
Conditioned air is discharged in a single downward direction through the ceiling assembly. Airflow direction is not adjustable via louvers on this model. For multi-directional or duct-distributed airflow, confirm your duct layout before selecting this assembly.
The Furrion Chill lineup transitioned to R32 refrigerant for its 2025 and later production runs. R32 is a lower-GWP (global warming potential) refrigerant that requires R32-rated components throughout the system. This ceiling assembly is engineered and rated for R32 compatibility -- it is not interchangeable with older Chill units that use R410A or R22 refrigerants.
Always verify your rooftop unit's refrigerant type before ordering a replacement or additional ceiling assembly. The refrigerant type is printed on the rooftop unit label.
This ceiling assembly supports both installation methods. In a non-ducted setup, all cooled air exits directly downward through the ceiling box into the main living area. In a ducted setup, the ceiling assembly connects to a duct distribution system that routes conditioned air to multiple vents throughout the RV. Ducting hardware is sold separately and must be matched to your floor plan and rooftop unit capacity.
The detachable filter should be inspected every 2-4 weeks during active use. A clogged filter reduces airflow, forces the system to work harder, and can shorten compressor life. The filter is tool-free to remove -- pull it from the housing, rinse with warm water, allow to dry fully, and reinstall.
This ceiling assembly is designed for use with the Furrion Chill, Chill HE, and Chill Cube rooftop AC units on the R32 refrigerant platform (2025+). Confirm your rooftop unit model and refrigerant type match before installing this assembly. Furrion part number FACT11CA2-PS-AM; Lippert cross-reference LIP2024042642.