Stop fighting debris, standing water, and grit on top of your slide room. The Lippert Solera slide out topper fabric (part LIP432253) is a universal-fit replacement roll built from 13.5 oz anti-scuff, anti-mildew vinyl -- the same tough material used on factory-installed toppers. Cut it to the exact width of your slide, and you have a tight, clean fit with no leftover guesswork.
A failing slide topper lets water pool directly on your slide seals, accelerating deterioration and letting debris work its way inside. This Solera replacement roll gives you a full 50 feet of fabric so one purchase covers nearly any slide width -- whether you have a short 10 ft bedroom slide or a 20 ft living room monster. The 50-inch depth (the dimension that wraps over the roller tube) provides ample coverage for standard and deep-profile slide rooms.
Heated wedge welding fuses all seams, creating a bond that resists leaks and separation far better than stitched or glued alternatives. Once unrolled, the anti-scuff surface sheds dirt and resists the mildew growth that is common in humid or frequently-wet climates.
Full 50 ft roll cuts cleanly to your exact slide width -- no waste, no ordering a custom panel.
Heated wedge welding fuses vinyl layers for strong, leak-resistant seams that won't pull apart under tension.
13.5 oz vinyl resists surface scuffing from slide operation and inhibits mildew growth in wet conditions.
Perforated pull tab lets you draw out only the fabric you need while keeping the rest clean and protected in the box.
This fabric roll is designed to fit Solera, Carefree, and Dometic slide out topper hardware. If your existing fabric is worn, torn, faded, or holding water, this roll is a direct material replacement. You keep your existing roller tube, end caps, and mounting hardware -- only the fabric changes.
Replacing slide topper fabric is a manageable DIY job for most RV owners with basic hand tools. The general process involves removing the roller tube assembly, pulling off the old fabric, attaching the new fabric to the tube, and rolling it onto tension. Because this roll is 50 ft long, you cut it to the width of your specific slide before installation -- allow a small trim margin on each side so the fabric seats cleanly inside the end caps.
Lighter vinyl (under 10 oz) can stretch, tear at the leading edge, or flap in highway wind. At 13.5 oz, this fabric holds its shape under tension and resists wind-driven flapping at travel speeds. The added mass also helps the fabric unroll smoothly rather than billowing away from the slide when extended.