Reduce front-to-back and side-to-side movement in a parked fifth wheel with the Ultra-Fab Economy King Pin Tripod Stabilizer. Its heavy-duty steel design supports up to 5,000 lbs. and adjusts from 31" to 54" for a secure fit beneath the king pin.
The Ultra-Fab Economy King Pin Tripod stabilizes the front of an unhitched fifth-wheel trailer to help reduce vibration, rocking, and frame movement while parked. Its three-leg steel design spreads the load across a wide footprint while the adjustable hitch cup provides fine-tuned contact with the trailer king pin.
The tripod adjusts from 31" to 54" high and supports up to 5,000 lbs. Large 5" x 5.5" footpads help resist sinking and tilting on softer ground, while the included chain secures the legs in position and the supplied padlock helps prevent removal from the king pin.
Heavy-duty design stabilizes the front of compatible fifth-wheel trailers
Wide height range accommodates a variety of fifth-wheel setups
Oversized pads help resist sinking and tilting on softer surfaces
Heavy-duty steel construction remains manageable for setup and storage
This tripod is designed only to stabilize a parked fifth-wheel trailer. It is not a lifting jack and must not be used as a replacement for the trailer's landing gear.
In The Package: • Ultra-Fab 19-950500 Economy King Pin Tripod Stabilizer • Adjustable King Pin Cup Assembly • 3 Steel Tripod Legs • 3 Footpads with Retaining Clips • Chain with S-Hook • Padlock • Preassembled Tripod Hardware
Position the tripod below the fifth-wheel king pin, raise the adjustable cup over the king pin, secure the chain around the three leg brackets, and tighten the cup until snug. Ultra-Fab states that two or three additional turns are normally sufficient for stabilization.