Keep your travel trailer showroom-ready between trips. The ADCO Designer Series SFS Aquashed cover wraps your rig in a breathable, water-shedding triple-layer shell that fights UV rays, humidity, and rainfall without trapping the moisture that causes mold and mildew. Purpose-built for travel trailers up to 15 feet long, this cover ships ready to install with a full buckle cinch and strap system that stays put even in gusty conditions.
The SFS Aquashed name describes the actual fabric technology at work here. SFS stands for "Spunbond-Film-Spunbond" -- a sandwich construction where a thin polypropylene film is bonded between two spunbond layers. The Aquashed treatment adds a water-beading finish on top of that. This revision of the Designer Series cover ships with 30% more SFS Aquashed material in the top panel compared to earlier generations, giving you a meaningfully thicker barrier right where rain and sun hit hardest.
The side panels use triple-layer polypropylene -- lighter than the top but still durable enough to handle scraping branches, dust, and the occasional careless neighbor. The overall construction is breathable by design: moisture vapor passes out through the fabric rather than condensing inside against your trailer's walls, roof, and seals.
30% more SFS Aquashed material versus previous generation. Beads water on contact and resists high humidity at the roof and upper sidewalls where exposure is greatest.
Triple-layer polypropylene side panels allow moisture vapor to escape, preventing the trapped-humidity environment that leads to mold, mildew, and delamination damage.
Front and rear buckle cinching removes slack so the cover conforms to the trailer profile. Bottom-mounted strap-and-buckle system anchors the cover against wind lift -- no flapping, no creep.
Access your trailer's doors, compartments, and utilities without removing the entire cover. Zipper panels let you check on your rig, grab gear, or run a connection during storage without a full uncover cycle.
Installing a travel trailer cover solo is genuinely difficult -- bunching fabric, crawling under the coach to thread straps, fighting wind while you try to align the front. ADCO engineered several features specifically to reduce that friction:
Unlike waterproof tarps or poly sheeting, the SFS Aquashed fabric lets water vapor escape. Trapped moisture is the primary driver of mold, mildew, delamination, and seal deterioration during storage. This cover is designed to breathe, not just repel.
ADCO rates the Designer Series SFS Aquashed for moderate climates and short-to-medium term storage. "Moderate" means areas that see real rainfall and humidity but not sustained extreme conditions -- think the Southeast, Midwest, mid-Atlantic, and similar regions with defined seasons but without the prolonged heavy snow loads of mountain or northern tier winters.
This cover is an excellent choice for spring-through-fall storage or full-season storage in mild climates. For storage in areas with heavy, sustained snowfall or extreme UV exposure (high desert, mountain elevations), consider ADCO's SFS AquaShed Plus or Tyvek-based options that are engineered for those conditions.
This cover is built for travel trailers up to 15 feet in length. The cover dimensions are 15 ft long x 96 inches wide x 90 inches tall (length x width x height). Measure your trailer's overall length including the tongue hitch before ordering. If your trailer is even a foot over this cover's length limit, size up -- a cover that is stretched or poorly seated will wear prematurely and may allow wind infiltration.
The ADCO 01-0233 ships as a single cover unit with the integrated buckle and strap system already attached. No separate storage bag purchase is required -- a carry bag is included for off-season storage of the cover itself. There are no additional poles, frames, or support kits included or required.
Before covering, clean and dry the trailer exterior. Inspect roof seams and vents -- a cover will not stop water intrusion through failed caulking. Periodically check that straps remain tensioned during storage, especially after high-wind events. When removing the cover, fold rather than stuff to avoid crease-set damage to the SFS layer. Store the cover clean and dry in the included bag.