Reach batteries mounted in tight compartments, slide-out bays, or across a garage without moving your charger. The DCE25 adds a full 25 feet of heavy-duty extension between any compatible BatteryMINDer charger and its SAE DC outlet connection, using the same SAE bullet connector standard the charger already uses.
RV batteries are rarely in a convenient spot. Engine compartments, underbelly bays, basement storage -- all create situations where a standard charger lead simply does not reach. The BatteryMINDer DCE25 solves that with 25 feet of 16-gauge zip cord terminated in reliable SAE "bullet" connectors on both ends, so you plug in at the charger and clip on at the battery without stretching, repositioning, or running a separate extension cord to a wall outlet.
The 16-AWG rating is matched to the typical current draw of BatteryMINDer maintenance and desulfation chargers, keeping voltage drop across 25 feet within acceptable limits for proper charging performance. The cable weighs just 1 lb, coils easily for storage, and is built to last with a 5-year limited manufacturer warranty behind it.
Industry-standard SAE plug-and-play connection matches BatteryMINDer charger output leads -- no tools, no splicing, no adapter needed.
Long enough to span most garage bays or reach deep underbelly battery compartments from a single wall-mounted or nearby charger location.
Heavy-duty 16 AWG wire handles the current demands of BatteryMINDer chargers while keeping resistive voltage drop minimal over the full 25 ft run.
Backed by BatteryMINDer's limited 5-year manufacturer warranty, the same coverage offered across the BatteryMINDer charger lineup.
The DCE25 uses the universal SAE bullet connector standard. It is compatible with most BatteryMINDer charger models that use an SAE DC output lead, including 12V maintenance, float, and desulfation chargers in the BatteryMINDer lineup. No wiring or crimping required -- connect charger to cable, cable to battery.
This 16-gauge cable is sized for BatteryMINDer low-amperage maintenance and desulfation chargers (typically 2A to 12A output). Do not use this extension with high-output bulk chargers rated above the cable's capacity. Check your charger's rated output amperage before use.