A direct OEM-style replacement propane pigtail hose for RV liquid propane systems. This 36-inch rubber hose connects your LP tank via a standard POL fitting on one end and a 1/4" male inverted flare on the other -- the same configuration found on most factory RV propane systems. UL and CSA listed for peace of mind on every hookup.
The JR Products 06-0129 is built to replace worn, cracked, or outdated propane pigtail hoses on travel trailers, fifth wheels, motorhomes, and other RVs that use a standard POL tank connection. At 36 inches, it gives you enough reach to connect a horizontal or vertical LP cylinder without kinking.
Both ends match the fittings found on OEM RV propane systems: a left-hand-thread POL fitting that seats securely on any standard ACME or POL-style propane cylinder valve, and a 1/4" male inverted flare that connects to your coach-side LP regulator or manifold.
Left-hand-thread POL fitting seats onto standard propane cylinder valves -- no tools or seal tape required for proper engagement.
Coach-side end threads directly into standard RV regulator inlets and LP manifold ports with a wrench-tightened metal-to-metal seal.
1/4" ID rubber hose resists LP fuel degradation and stays flexible across a wide temperature range for reliable service in all seasons.
Independently certified to UL and CSA standards for LP gas service -- required by many campground inspectors and RV techs.
This pigtail is the link between your portable propane tank and your coach propane regulator. It is commonly found on:
No special tools are required beyond two open-end wrenches. Close the tank valve before disconnecting the old hose. Hand-tighten the POL fitting first -- POL fittings seal by compression, not thread tape -- then snug it with a wrench. Use a wrench to tighten the inverted flare end at the regulator. After installation, check all connections with a leak-detection solution or approved gas-leak detector before opening the tank valve fully.