Keep your hydraulic slide-out operating smoothly with this genuine Lippert replacement flush head assembly. Designed specifically for 2.5 x 2.5 hydraulic through-frame slide-out systems, this adjustable head mounts on the passive (follow) side of the slide mechanism and ensures consistent flush contact and alignment as the room extends and retracts.
Lippert's V-Tech slide-out system is one of the most widely used hydraulic through-frame slide mechanisms in the RV industry, found on a broad range of fifth wheels, travel trailers, and toy haulers. Over time, flush heads can wear, crack, or lose adjustability due to repeated cycling and road stress. This 119157 assembly restores proper head alignment and contact, helping prevent room racking, edge wear on seals, and retraction issues.
The adjustable design allows technicians and DIY owners to fine-tune the head position so the slide room sits flush with the coach sidewall when retracted -- critical for both weather sealing and aerodynamics on the road.
Mounts on the non-driven side of the slide-out, following the primary actuator to keep the room square and flush during travel.
Field-adjustable positioning allows precise flush alignment against the coach sidewall without shimming or improvised fixes.
Engineered specifically for 2.5-inch x 2.5-inch hydraulic through-frame slide-out track systems -- not compatible with round-tube or electric rack-and-pinion systems.
Direct replacement from Lippert Components -- no modifications required for compatible V-Tech through-frame installations.
In a through-frame slide-out system, the slide room tube passes entirely through the RV frame. A flush head assembly is the hardware mounted at the outer end of that tube on the passive side. It provides the contact surface that pushes and pulls the room, and its adjustability ensures the room face aligns evenly with the exterior wall when the slide is retracted.
When a flush head is bent, cracked, seized, or no longer adjustable, the room may not retract fully, may sit proud of the sidewall on one corner, or may put uneven stress on slide-out seals. Replacing it with the correct OEM part is the proper fix.