A cracked, yellowed, or hinge-broken vent lid does more than look bad -- it lets in rain, road debris, and cold drafts. The Lippert 2023054272 Vent Fan Lid Replacement Kit gives you everything needed to restore a standard 14 x 14 inch RV roof vent to full working condition without pulling the entire vent frame. Drop-in fit, minimal tools, minimal time on the roof.
RV roof vent lids take constant punishment. UV exposure yellows and embrittles the plastic, hail and branches crack the dome, and repeated opening cycles stress the hinge points until they snap. Replacing the full vent frame means cutting old sealant, risking roof penetration damage, and spending hours on a ladder. This Lippert lid kit lets you swap only the worn component -- typically in under 30 minutes.
Part number 2023054272 (vendor reference 08-7675) is a factory-sourced lid assembly sized for the standard 14 x 14 inch vent opening found on a wide range of travel trailers, fifth wheels, and motorhomes. If your existing vent frame and base are intact, this kit restores weathertight function and clean appearance without disturbing the roof seal.
Sized for the most common RV roof vent opening. No cutting or trimming needed.
Molded from UV-stabilized polypropylene to resist yellowing and brittleness over time.
Comes with mounting hardware so you are not hunting for odd fasteners on install day.
No need to disturb the vent frame, base, or roof sealant. Existing frame stays in place.
This lid kit is designed for Lippert-branded roof vents with a standard 14 x 14 inch opening -- the same format used on a large share of Lippert-equipped trailers and motorhomes built over the past decade. Before ordering, confirm:
If your vent was originally supplied by Lippert Components (commonly found on Forest River, Coachmen, and many other OEM brands), this is a strong match. Vendor part number 08-7675 can be used to cross-reference with dealer parts systems.