This small but essential roll pin is a required component when installing the Lippert 113406 Rear Electric Stabilizer Jack Adapter. If you are replacing or installing that adapter and the pin is missing, damaged, or lost, this is the exact OEM replacement you need to complete the job correctly.
Roll pins are precision-fit fasteners that lock rotating or sliding components in a fixed position. In the context of the Lippert 113406 stabilizer jack adapter, the roll pin secures the adapter assembly so it does not shift or back out under load. Using the correct diameter and length is critical -- an undersized pin will not hold, and an oversized pin will not seat properly.
Lippert part number 181003 is a slotted spring-type roll pin measuring 3/32" (0.09375") in diameter and 1.0" in length. It is used together with roll pin 125462 to complete the full installation of the 113406 rear electric stabilizer jack adapter.
Genuine Lippert replacement hardware sized exactly to spec for the 113406 adapter assembly.
Slotted cylindrical construction compresses on installation and expands to grip the bore for a secure, vibration-resistant hold.
At 1.0" long, this pin spans the full engagement depth required by the 113406 adapter housing.
Must be used alongside Lippert roll pin 125462 to fully complete the 113406 adapter installation.
The Lippert 113406 is a rear electric stabilizer jack adapter with a 9/16" to 5/8" I.D. and 7/8" O.D., 2-1/2" overall length. It is commonly used on RV slide-out and stabilizer systems where the electric jack shaft requires an adapter to interface with the mounting point. Both roll pins -- 125462 and 181003 -- must be installed to properly secure this adapter.