Lippert 241316 4 Pin Interface Harness (10 ft)

Lippert 241316 is a 10 ft 4 pin interface harness used to connect a compatible Lippert leveling control panel / control module (including 242623-4) to a compatible touchpad (including 421484). If your original cable is damaged, missing, or too short, this is the correct plug-and-play replacement to restore touchpad-to-controller communication.

What This Harness Does

• Connects the leveling touchpad to the leveling control module
• Restores communication so the touchpad can command the system
• Replaces a cut, pinched, corroded, or missing 4 pin interface cable

Key Features

• Correct length: 10 ft for clean routing through cabinets, walls, and bays
• 4 pin interface: Designed for Lippert systems that use a 4 pin touchpad connection
• Plug and play: No splicing required in most installations
• Cleaner install: Helps avoid extensions and wiring hacks that cause intermittent issues

Compatibility

This harness is commonly used with:

• Control panel / control module: Lippert 242623-4
• Touchpad: Lippert 421484

Specifications

Installation Notes

1. Disconnect RV battery power before servicing the leveling system.
2. Unplug the old harness from the control module and the touchpad.
3. Route the new harness away from sharp edges, heat sources, and moving parts.
4. Secure with zip ties or clamps to prevent chafing.
5. Reconnect power and verify touchpad operation.

Quick Troubleshooting

If the touchpad still does not respond after replacing the harness, check:

• 12V power and ground at the control module
• Fuse(s) for the leveling system
• Connector pins for corrosion, bent terminals, or loose fit

FAQ

Is this the harness I need to connect control panel 242623-4 to touchpad 421484?

Yes, Lippert 241316 is the 10 ft 4 pin interface harness commonly used for that touchpad-to-controller connection.

Can I use this to replace a shorter cable?

Yes. As long as the connectors match your system, the 10 ft length is ideal for cleaner routing and fewer connection issues.