Direct replacement front cover for the drive head (motor side) of Lippert Edge RV awnings. When the original cover cracks, fades, or breaks from UV and weather exposure, part 771407 restores a clean, finished look and protects the drive head internals. Vendor part number 08-3911. Specific to Lippert Edge awning drive heads -- not a universal fit.
The drive head is the motor-powered end of your Lippert Edge awning arm assembly. It houses the motor mechanism and drive components that extend and retract the awning. The front cover -- part 771407 -- is the exterior-facing plastic panel on the motor side. It takes the brunt of road debris, UV radiation, and weather cycling, and over time it cracks, warps, or breaks entirely.
Replacing just this cover is far more practical than replacing the entire drive head assembly. Part 771407 snaps or screws into the original mounting points on the drive head housing, restoring a clean appearance and keeping dirt, moisture, and road grime out of the motor compartment.
Designed specifically for Lippert Edge series drive heads. Mounts to the original attachment points -- no drilling or modification needed.
Shields the motor-side drive head from road debris, moisture, and UV exposure that degrade internal components over time.
Matte black color matches the standard Lippert Edge awning hardware for a factory-correct appearance after replacement.
A cracked or broken cover is a common cosmetic failure on older Edge awnings. This part addresses that failure without replacing the entire arm assembly.
This is the motor-side (drive head) front cover -- the end of the awning arm where the motor is located. The opposite end (idler side) uses a different cover. Confirm which end needs replacement before ordering.
The Lippert Edge is a 12V electric RV slide-out awning designed to cover slideouts on travel trailers, fifth wheels, and motorhomes. The drive head assembly is the active end of the unit. This cover fits the front face of that drive head housing. If your awning model is an Edge (not the Solera, Impact, or other Lippert awning families), this part applies to your unit.
Lippert produces multiple awning families (Edge, Solera, Impact, and others). Part 771407 is specific to the Edge series drive head. Check the label on your existing drive head housing or reference your awning's original build sheet or Lippert's parts lookup using your VIN to confirm compatibility.
The front cover on the Lippert Edge drive head typically retains with a combination of plastic snap tabs and/or small fasteners around the perimeter of the housing. Replacement involves:
Retain any original hardware (screws, clips) removed from the damaged cover -- they are typically reused with the replacement.
After installing the new cover, inspect the seal around the drive head housing for any gaps. A bead of compatible RV sealant around the cover edge can provide additional moisture protection, especially if the rig is parked in rainy or high-humidity environments.