A clean, purpose-built access door solution for Girard tankless water heater installations in existing Atwood or Dometic 6-gallon water heater compartment openings. Hinged design with a sliding latch keeps components accessible and protected on the road.
When you swap out a traditional Atwood or Dometic 6-gallon tank-style water heater for a Girard tankless unit, you are left with the original exterior wall cut-out. The Girard 2GWHDA6B installation kit (Lippert part 11-9191) provides the door panel and hardware needed to properly finish that opening -- giving your rig a factory-clean look while maintaining easy access to the tankless unit's controls, igniter, and service connections.
The door measures 15 x 18.5 inches overall and is finished in black to blend with standard RV exterior trim. The hinged design swings open fully for hands-free access, and a sliding latch keeps the door securely closed over highway miles and rough terrain.
Full-swing hinge allows unobstructed access to water heater components without holding the door open by hand.
Positive-engagement sliding latch keeps door closed during travel and resists vibration-induced opening.
Engineered to cover the standard Atwood and Dometic 6-gallon water heater exterior opening -- no custom trimming required for compatible cut-outs.
Matches common RV exterior trim and compartment door colors for a finished, OEM-style appearance after a tankless conversion.
This kit is specifically intended for Girard 2GWHD-series tankless water heater installations where the existing 6-gallon exterior opening is being reused. It provides the door assembly needed to complete the exterior finish of the conversion -- saving custom fabrication time and ensuring a weather-tight fit.
This door kit is matched to the standard exterior rough opening used by Atwood GH6P, GCH6E, GH6E and Dometic/Atwood 6-gallon water heaters. If your existing opening dimensions differ from the standard 6-gallon footprint, measure the opening before ordering. The door panel itself measures 15 x 18.5 inches.
This is a door and hardware installation kit only. The Girard tankless water heater unit is sold separately. This kit does not include the water heater itself, any gas or water line fittings, or venting components.