A rugged, USA-made high-pressure propane hose built for demanding RV and outdoor appliance connections. Rated to 350 PSI and certified to UL and CGA standards, this 12-foot hose gives you the reach and reliability needed to connect your RV propane supply to high-pressure burners, turkey fryers, generators, patio heaters, and other appliances that operate above standard low-pressure regulator output.
Most RV appliances -- furnaces, water heaters, refrigerators -- run on low-pressure propane regulated to 11 inches of water column. But campsite cooking equipment, high-output burners, and certain outdoor appliances require a direct high-pressure propane feed upstream of or bypassing the standard regulator. That is exactly where the MB Sturgis 06-1379 belongs.
With a 3/8" female flare swivel inlet and a 3/8" male pipe thread (MPT) outlet, this hose bridges your propane source to a wide range of high-pressure appliances and fittings without adapters in most setups. The swivel end eliminates hose twist during connection, reducing stress on fittings and the hose itself over repeated use.
Handles full propane cylinder vapor pressure well above typical working pressures, providing a substantial safety margin in high-pressure appliance lines.
Gives you 12 feet of flexible reach from your propane source to your appliance -- useful for campsite setups, tailgating, and RV connections without straining fittings.
The 3/8" female flare swivel rotates freely during tightening so the hose body stays relaxed and untwisted, protecting both the hose and the mating fitting.
Independently certified to UL and CGA standards for propane service. Manufactured in the United States with materials and construction that meet rigorous LP gas requirements.
Understanding the two end connections will confirm this is the right hose for your application:
MB Sturgis builds this hose for commercial-grade LP gas service. The inner core is compatible with liquefied petroleum gas and constructed to resist the permeation and degradation that propane causes in lower-quality rubber hoses. The outer jacket resists weathering, UV, and the abrasion typical of campsite and outdoor use.
Brass end fittings -- the industry standard for propane -- resist corrosion and provide the sealing integrity required for UL and CGA certification. The female flare swivel uses an internal sealing design that does not require thread sealant or tape on the flare connection (flare connections seal on the cone, not the threads).