Connect a quick-disconnect propane appliance directly to your RV's quick-connect port with this 48-inch dual quick-connect LP hose. With a Model 250 male plug on one end and a Model 250 female socket on the other, this hose bridges an appliance's male QD fitting to a female QD outlet already on your rig -- no adapters, no thread-matching headaches. UL/CGA approved and Made in the USA.
Whether you're running a portable LP grill, a camp stove, or a small propane heater from your RV's onboard supply, the MB Sturgis 100395-48-MBS gives you a convenient 48-inch extension between a female quick-disconnect outlet and any appliance equipped with a male Model 250 quick-disconnect plug. The 48-inch length is practical for outdoor cooking setups where the appliance sits on a picnic table or side deck away from the RV wall port.
The hose itself is a 1/4" ID thermoplastic assembly -- flexible across a wide temperature range and rated for continuous LP gas service. Both end fittings follow the Model 250 quick-disconnect standard, which is the most widely used QD format in the RV propane accessory market.
Male Model 250 QD plug on one end, female Model 250 QD socket on the other -- connects appliance-to-RV port without tools or thread adapters.
Maximum working pressure of 350 PSI -- well above typical RV LP system pressures (usually 11" water column / under 1 PSI after regulation).
Rated from -40F to 140F (-40C to 60C), handling cold-weather camping and warm outdoor cooking environments without cracking or stiffening.
Meets UL and CGA safety standards for LP gas hose assemblies. Manufactured in the USA with a limited 1-year manufacturer warranty.
The "Model 250" designation refers to the most common quarter-inch quick-disconnect standard used in RV propane systems. These fittings automatically seal when disconnected, so you don't need to shut off a valve every time you unplug a portable appliance. The male plug snaps into the female socket and locks under gas pressure; a collar release disconnects it. Many RV manufacturers install female Model 250 QD ports directly on the exterior LP bulkhead for just this purpose.
This hose is designed to go between two quick-connect points -- a female QD outlet (on the RV wall or a distribution manifold) and a male QD plug (on the appliance). If your appliance has a POL, ACME, or 1/4" inverted flare connection instead of a male QD plug, this hose is not the right fit.
The hose body is a 1/4" ID thermoplastic construction -- lighter and more flexible than rubber hoses of the same rating, while still delivering the pressure margin and temperature range needed for safe LP gas service. The fittings are brass, which is standard for LP quick-disconnect assemblies and compatible with propane without corrosion concerns.
No tools are required to connect or disconnect this hose. To connect: push the male QD plug firmly into the female QD socket until it clicks. To disconnect: pull back the collar on the female socket and pull the hose free. Always confirm the gas supply is off before disconnecting during storage or transport.