20 ft replacement control / communication cable for compatible MaxxAir wall control panels and MaxxFan Plus 4-speed roof vent models.
The Maxxair 10-010000 is a 20 ft replacement control cable used between compatible MaxxAir wall control panels and select MaxxFan roof vent assemblies. If the original cable is damaged, pinched, cut, loose, or no longer allowing proper communication between the wall control and fan, replacing the cable may help restore normal control operation.
This cable is commonly listed for MaxxAir Plus wall control panel 00A03550K and MaxxFan Plus 4-speed roof vents 00-04751KS and 00-04951KS. Because Maxxair vent wiring and control setups vary by fan model, verify your wall control, fan model, and cable style before ordering.
Replacement 20 ft control cable for compatible MaxxAir wall-control setups
Connects compatible MaxxAir wall control panels to supported MaxxFan roof vents
Commonly listed for 00-04751KS and 00-04951KS 4-speed roof vent models
Useful when the original control cable is damaged, loose, or faulty
This cable is not universal for every Maxxair roof vent. It is commonly listed for specific wall-control MaxxFan Plus applications, including wall control panel 00A03550K and roof vent models 00-04751KS and 00-04951KS. Before ordering, verify the fan model, wall control model, cable length, and connector style.
Before Starting: Disconnect power to the roof vent fan before servicing wiring or control components. Basic Replacement Steps: 1. Confirm Compatibility: Verify the fan model, wall control model, cable length, and connector style before removing the original cable. 2. Disconnect Power: Turn off power to the fan circuit to help prevent electrical damage or accidental operation. 3. Access Cable Ends: Locate the cable connection at the wall control panel and the roof vent / fan assembly. 4. Document Routing: Note the cable routing before removal, especially if it passes through cabinetry, ceiling panels, or wall cavities. 5. Remove Old Cable: Disconnect the old cable carefully without damaging the control panel or fan-side connector. 6. Route Replacement Cable: Route the new cable in the same path where possible, avoiding sharp edges, pinch points, and heat sources. 7. Connect Cable Ends: Plug the replacement cable into the correct wall control and fan connections. 8. Test Operation: Restore power and confirm fan speed, lid/control functions, and wall control response.
Package Contents: • Maxxair 10-010000 20 ft replacement control cable NOT Included — May Also Need: • Wall control panel • Roof vent fan assembly • Fan motor or circuit board • Wire retainers, clips, or routing hardware • Interior garnish or trim parts This listing is for the replacement cable only. Inspect the wall control, fan-side connector, and circuit board if the fan still does not respond after cable replacement.
To confirm compatibility before ordering, have the following ready: • Roof vent / fan model number • Wall control panel model number • Existing cable length • Photos of both cable connectors, if available • Description of the fan/control issue being diagnosed Why this matters: Maxxair wall-control cables can vary by fan series and control setup. Matching the fan model, wall control model, cable length, and connector style helps avoid ordering the wrong cable.
Match this cable by Maxxair fan model, wall control model, length, and connector style. Similar modular cables may not be wired the same internally.
If replacing the cable does not restore operation, inspect the wall control, fan-side connector, power supply, fuse, and control board before replacing additional parts.