Keep your molded fiberglass camping trailer protected year-round with the Classic Accessories PolyPro 3 cover. Engineered specifically for the rounded profiles of fiberglass camping trailers, this cover combines a thick triple-ply top with integrated air venting, zipper access panels, and a rope-assist installation system -- so your rig stays protected and getting the cover on and off stays manageable for one person.
Not all trailer covers fit the curved, low-profile shape of a molded fiberglass camping trailer. The Classic Accessories 01-0908 is sized and shaped specifically for this trailer style, fitting units up to 13-16 ft long and 7 ft wide. The elasticized hem corners and adjustable front and rear tension panels conform to the trailer body rather than billowing or bunching around the curves.
The cover weighs 11.2 lbs -- manageable for solo installation -- and ships with a storage bag so folding and stowing at the start of camping season is straightforward. An integrated rope attachment system and included toss bag let you run the tie-down ropes under the trailer without crawling on the ground.
Thick three-layer fabric on the roof and high-exposure surfaces blocks rain, snow, UV rays, dirt, and minor abrasion all season long.
Lighter single-ply panels on the sides reduce overall weight while still protecting against dust, dirt, scratches, and wind-driven moisture.
Built-in vents reduce wind-load pressure on the cover and allow interior moisture to escape, helping prevent mold and mildew under the cover during storage.
Zippered panels provide access to RV entry doors and storage compartments without removing the entire cover, plus a rear full-height zipper accommodates toy hauler access.
The integrated rope channels and the included toss bag let you thread the securing ropes under the trailer frame without crawling under the rig. Solo installation is practical with this system on a flat surface.
Classic Accessories uses a layered approach in the PolyPro 3 line. The top and front-facing panels use three-ply PolyPro 3 fabric for maximum protection where UV and precipitation exposure is highest. The side panels use single-ply PolyPro 1 fabric to keep the overall cover weight manageable at 11.2 lbs while still repelling dust, dirt, and light moisture. Both fabrics are quick-drying.
This cover (01-0908) is designed for molded fiberglass camping trailers in the 13-16 ft length range and up to 7 ft wide. It is NOT intended for standard travel trailers with boxy or vertical-sidewall profiles. If your trailer has a conventional squared-off shape, a different cover SKU in the Classic Accessories lineup will fit better. Measure your trailer's overall length (tongue excluded) and maximum body width before ordering.