Home > LP Gas > LP Hoses >

Marshall Excelsior MER413-144 3/8" Female Flare x 3/8" Female Flare Propane Hose 144 Inch

Marshall Excelsior MER413-144 144-inch 3/8 inch female flare x female flare flexible thermoplastic propane hose with crimped brass ferrules
Marshall Excelsior 3/8" Female Flare x 3/8" Female Flare Propane Hose - 144"
 
List Price: $56.99
: $41.49
You save $15.50!
Part Number: MER413-144
Manufacturer: Marshall Excelsior

Quantity in Stock :19

Availability: In Stock
Qty:

 
Marshall Excelsior 350 PSIG Rated Made in USA MER413-144 -- 3/8" Female Flare x 3/8" Female Flare Propane Hose, 144 Inches

A full 12 feet of flexible, UL- and CGA-approved LP gas hose built for RV propane systems. The Marshall Excelsior MER413-144 delivers a safe, reliable connection between your RV's propane regulator, tanks, or appliance supply lines -- with the pressure rating and pull-test strength to handle real-world road vibration and use.

Twelve Feet of Trusted LP Gas Hose for RV and Trailer Applications

When your existing propane hose is too short to reach a second tank, a remote regulator, or a slide-out appliance hookup, the MER413-144 gives you 144 inches of flexible reach without compromising safety. Both ends are 3/8" female flare (SAE 45-degree), the standard fitting found on most RV LP regulators, tank POL adapters, and appliance inlet valves.

The thermoplastic inner core is surrounded by a reinforced outer jacket with integral thermal protection. Both ferrules are fully crimped brass -- no clamps to re-tighten, no hose-clamp failures. This is a hose you install and trust.

350 PSIG Working Pressure

Rated for high-pressure propane supply lines well above typical RV operating pressures, providing a substantial safety margin in any LP gas application.

400 lb. Pull Test Rating

Crimped brass ferrules withstand a 400 lb. pull-force test, keeping connections secure even when the hose is routed through tight spaces or subject to vibration.

UL and CGA Approved

Meets Underwriters Laboratories and Compressed Gas Association standards -- the certifications campground hosts, RV parks, and propane dealers look for before approving connections.

Made in USA

Manufactured by Marshall Excelsior, a Michigan-based company with decades of LP gas equipment experience. Backed by a limited 5-year manufacturer warranty.

Fitting Compatibility and Common Uses

Both ends of this hose use a 3/8" female flare (SAE 45-degree) fitting. This connection type is standard across the RV propane world and mates directly with:

  • Marshall Excelsior and other brand dual-stage and single-stage regulators with 3/8" male flare outlets
  • Propane appliance inlet fittings on ranges, furnaces, and water heaters using 3/8" male flare
  • Pigtail hose manifold inlets on multi-tank LP systems
  • T-fittings and tee adaptors in RV propane distribution manifolds

If your regulator or appliance uses a 1/4" male flare outlet, you will need a 3/8" to 1/4" flare adapter (not included). Always confirm thread size before installation.

Full 12-Foot Length Advantage: At 144 inches, this hose is long enough to span from a frunk-mounted dual-tank regulator to an appliance connection inside many Class A and Class C coaches, or to reach a second external tank placed several feet from the primary connection point. It's also a popular choice for dedicated outdoor grill or griddle hookups at the RV's external LP quick-connect location.

Construction and Safety Features

Marshall Excelsior builds the MER413-144 to exceed the demands of mobile propane installations:

  • Thermoplastic inner tube -- compatible with LP gas (propane), resistant to cracking and stiffening across a wide temperature range
  • Reinforced outer jacket with thermal protection -- helps resist radiant heat near engine bays, generator enclosures, or external compartment walls
  • Fully crimped brass ferrules -- factory-crimped, not field-attached, ensuring a leak-free mechanical connection at both ends
  • 1/4" hose inner diameter -- adequate flow for most single-appliance propane supply runs at typical RV operating pressures
Leak Test After Installation: Always perform a leak test with soapy water or an approved leak-detection solution after connecting any propane hose. Turn on the gas supply and check every fitting for bubbles before lighting any appliance or igniting any source of flame.
Maintenance Tip: Inspect this hose annually for abrasion, kinking, UV degradation, or fitting corrosion. If the outer jacket shows cracking or the ferrules show pitting, replace the hose regardless of remaining warranty period. LP gas hoses in exterior RV compartments should be inspected more frequently -- twice per year is a good practice for full-timers or year-round users.

Warranty

This hose is backed by a limited 5-year manufacturer warranty from Marshall Excelsior against defects in materials and workmanship. The warranty does not cover damage from improper installation, mechanical abuse, or use outside the rated specifications.

Product Specifications

ManufacturerMarshall Excelsior
Part NumberMER413-144 (SKU: 06-0039)
UPC815505010320
Country of OriginMade in USA
WarrantyLimited 5-Year Manufacturer Warranty
Weight1 lb.

Hose Dimensions

Overall Length144 inches (12 feet)
Hose Inner Diameter1/4 inch
Hose Outer DiameterApproximately 1/2 inch (typical of this series)

Fitting Specifications

Inlet Connection3/8" Female Flare (SAE 45-degree)
Outlet Connection3/8" Female Flare (SAE 45-degree)
Ferrule MaterialBrass, fully crimped
Ferrule AttachmentFactory crimped (not field-attached)

Pressure and Safety Ratings

Working Pressure350 PSIG
Pull Test Rating400 lbs.
CertificationsUL Listed, CGA Approved
Thermal ProtectionIncluded (integral to outer jacket)

Hose Construction

Inner Tube MaterialFlexible thermoplastic
Outer JacketReinforced thermoplastic with thermal protection
Gas CompatibilityLP Gas (Propane)

What Is Included

Included1x 144-inch propane hose with 3/8" F Flare x 3/8" F Flare fittings
Not IncludedAdapters, regulators, fittings, thread sealant
Important Information -- Read Before Installing
  • This hose is rated for LP gas (propane) only. Do not use with natural gas, compressed air, oxygen, or any other gas or fluid.
  • Maximum working pressure is 350 PSIG. Never exceed this rating. Do not use on high-pressure cylinder outlets without an appropriate regulator upstream.
  • Always perform a leak test with approved leak-detection solution after every installation or reconnection. Never use an open flame to check for leaks.
  • Do not install with sharp bends, kinks, or where the hose contacts moving parts, exhaust components, or sharp edges without protective sleeving.
  • Inspect the hose annually (or twice yearly for full-time RVers) for cracking, abrasion, UV damage, or corrosion at the ferrules. Replace immediately if damage is found.
  • Thread sealant or Teflon tape should NOT be used on flare fittings. Flare connections seal metal-to-metal; sealants can introduce contamination and prevent proper seating.
  • This product is intended for use by persons familiar with LP gas systems. If you are unsure about your installation, have it inspected by a certified LP gas technician.


Browse for more RV Accessories in the same category as this item:

LP Gas > LP Hoses
LP Gas


$26.49
$25.99
$1.72
$11.99