JR Products 07-31695 -- 60" OEM LP Supply Hose
A direct OEM-spec replacement for RV propane supply lines. The 07-31695 delivers a full 60 inches of flexible thermoplastic hose with a 1/2" female flare swivel on one end and a 3/8" male thread on the other -- designed to connect regulators, manifolds, and fixed LP system components without twisting or binding during installation.
When an LP supply hose shows cracking, stiffness, or fitting corrosion, it is not a part to defer. The JR Products 07-31695 is built to OEM specifications and serves as a drop-in replacement in the most common RV propane plumbing configurations. Its 60" length suits connections between a two-stage regulator and a distribution manifold, or between a coach LP bulkhead fitting and a fixed appliance supply line.
The 1/2" female flare swivel end allows the fitting to rotate freely as you thread and tighten without torquing stress into the hose body -- a practical advantage when working in tight propane compartments. The 3/8" male thread end is the standard thread used on most RV LP manifolds, regulator outlets, and inline shutoff connections.
Five full feet of hose -- enough reach for most regulator-to-manifold and bulkhead-to-appliance runs in standard RV LP compartment layouts.
1/2" female flare swivel rotates independently of the hose body, allowing wrench-tightening without twisting or kinking the line.
Meets Underwriters Laboratories and Canadian Standards Association requirements for LP gas hose assemblies used in recreational vehicle applications.
Flexible thermoplastic hose body resists LP gas permeation and remains pliable across a wide temperature range -- important for rigs stored in cold climates.
Getting the fittings right before ordering saves a return trip. Here is how the two ends of the 07-31695 are used in typical installations:
JR Products is an original equipment supplier to many North American RV manufacturers. The 07-31695 meets the same specifications as hoses installed at the factory, so it fits without modification in systems originally built with JR Products LP components.
Before installation, confirm your regulator outlet is a 1/2" male flare (not POL, not 9/16", not 1/4" NPT) and your manifold or downstream port is a 3/8" female thread. LP fittings are not interchangeable -- incorrect fitting engagement is a leak hazard. Use an approved LP thread sealant (not standard pipe tape) on the male thread end only; never apply sealant to flare connections.