A heavy-duty, bolt-on single entry step engineered for RV entry doors. The Hickory step combines a diamond-groove non-slip tread surface with a self-locking manual fold mechanism -- keeping the step secure while traveling and ready to use at camp. Built from powder-coated steel and made in the USA, this is a direct replacement for the discontinued Lippert 341499.
Slippery entry steps are one of the most common causes of RV trip-and-fall incidents. The Lippert 432678 Hickory step addresses that directly with a diamond-groove tread pattern machined into the steel surface, channeling water and providing grip even when the step is wet, muddy, or iced over. No rubber mat to replace, no grit tape to re-apply.
The step folds manually using a pivotal-action hinge and locks automatically in the folded position for travel -- so it stays tucked away on the road without a separate latch you might forget to set. At the campsite, the fold releases easily by hand.
Interlocking groove pattern channels water and debris, reducing slip risk in rain, sleet, mud, and ice conditions.
Pivotal-action hinge folds the step manually and locks it automatically in the travel position -- no separate pin or strap required.
Heavy-duty steel frame with a powder coat finish resists rust and corrosion through repeated exposure to road spray and weather.
Mounts directly to the RV frame or step bracket using standard bolt-on hardware. Mounting hole centers are 24" wide x 4" deep -- no welding required.
If your RV was built with the older Lippert step part number 341499, the 432678 Hickory is the current direct replacement. The mounting pattern and overall dimensions are the same, making it a drop-in swap on any rig that used the original 341499 step.
The 432678 installs with standard hardware through four bolt holes arranged on 24" wide x 4" deep centers. The step drops to a 7" rise from the ground-level position, which is consistent with typical Class A, Class C, and fifth-wheel entry door heights when used with existing step brackets.