The Dayton 1XJX7 is a complete replacement blower motor assembly designed for HVAC and ventilation applications requiring reliable, single-speed airflow. Unlike bare motors, this unit ships with the motor, sheet-metal housing, and blower wheel already assembled -- reducing installation time and eliminating fitment guesswork on the wheel and housing. Also catalogued as NBK Parts 20620.
Replacement blower motors often require sourcing a matching wheel and housing separately, which adds cost and complexity. The 1XJX7 ships as a ready-to-install assembly: the 9-3/8 in diameter blower wheel is mounted on the 14 mm shaft inside the formed housing, so you bolt it in place, wire it to your 115V supply, and you're done.
The motor runs at 1070 RPM and moves 1009 CFM at 60 Hz. It draws 3.7 amps, putting power consumption well within the range of standard 115V branch circuits. Ball bearings handle the shaft load for longer service life compared to sleeve-bearing alternatives in dusty or high-cycle environments.
Motor, blower wheel, and housing are all included. No separate sourcing required -- install as a complete drop-in unit.
Ball bearings support the 14 mm shaft for durability in continuous-duty and high-cycle ventilation applications.
Rated at 1009 cubic feet per minute at 1070 RPM -- suitable for furnace air handling, equipment cooling, and general HVAC ventilation.
Clockwise shaft rotation (viewed from the inlet side). Single-speed operation simplifies wiring and control circuit replacement.
This assembly is catalogued as NBK Parts 20620 in addition to the Dayton part number 1XJX7. Both numbers refer to the same unit. Cross-reference either number when ordering or verifying fitment with a distributor.
This is a 115V AC motor only. It is not compatible with 12V DC RV house power without an inverter supplying a clean 115V 60 Hz sine wave. Verify your application runs on 115V AC before ordering.