Home > LP Gas > LP Hoses >

Marshall Excelsior MECMER426H-15 15-Inch LP RV Pigtail Hose, Female QCC Type 1 x 1/4" MNPT, 350 PSIG

Marshall Excelsior MECMER426H-15 15-inch LP RV pigtail hose with female QCC Type 1 connector and 1/4-inch MNPT fitting, 350 PSIG rated with excess flow shutoff
Marshall Excelsior 15" LP RV Pigtail Hose - 1/4" MNPT
 
List Price: $31.48
: $27.99
You save $3.49!
Part Number: MER426H-15
Manufacturer: Marshall Excelsior

Quantity in Stock :14

Availability: In Stock
Qty:

 
Marshall Excelsior 350 PSIG Rated RVIA / NFPA 1192 Compliant Marshall Excelsior MECMER426H-15 -- 15" LP RV Pigtail Hose, QCC Type 1 x 1/4" MNPT

A wrench-free, safety-rated propane pigtail hose designed specifically for connecting the Marshall Excelsior MEGR-253 or MEGR-253H two-stage regulator to a standard LP cylinder. Built with dual safety features -- excess flow shutoff and a heat-sensitive displacement fitting -- this hose is a required component of any properly configured dual-cylinder RV propane system.

Reliable LP Connection with Built-In Safety Redundancy

The MECMER426H-15 pigtail hose is engineered for motorhomes, travel trailers, fifth wheels, and on-demand LP water heaters. The hand-tightenable female QCC (Quick Check Connector) Type 1 fitting threads directly onto a standard LP cylinder valve -- no wrench required. A swiveling nylon nut makes alignment and connection straightforward even in tight propane compartments.

Inside the brass nipple at the cylinder connection is a flow-limiting excess flow device. If a downstream failure causes gas flow to spike beyond safe limits, the device automatically restricts flow to a maximum bypass rate of 10 SCFH, protecting your system and coach from uncontrolled gas release.

Heat-Sensitive Safety Shutoff

Between 240 F and 300 F, the brass nipple displaces approximately 1/4 inch, mechanically closing the cylinder valve module and stopping gas flow from the container in a fire or high-heat event.

Excess Flow Protection

Built-in flow limiter detects abnormal downstream demand. If excess flow is sensed, the hose restricts output to a 10 SCFH bypass maximum until the condition is resolved.

Wrench-Free QCC Connection

Female QCC Type 1 swivel nut hand-tightens directly to a standard ACME-threaded LP cylinder valve -- no tools required, no POL adapter needed.

High-Pressure Thermoplastic Hose

1/4-inch ID high-pressure thermoplastic hose body with brass ferrules handles up to 350 PSIG working pressure and is 100% factory leak tested before shipment.

Designed for Dual-Cylinder RV Regulator Systems

This pigtail is specifically engineered to mate with the Marshall Excelsior MEGR-253 and MEGR-253H two-stage automatic changeover regulators. In a standard dual-cylinder RV setup, one pigtail connects each LP tank to the regulator. When the primary tank empties, the regulator automatically switches to the reserve -- the pigtail's QCC fitting allows the spent tank to be swapped without any tools.

It is also compatible with on-demand (tankless) LP hot water heaters and other high-BTU LP appliances that require a direct cylinder-to-regulator connection rated for high flow.

400,000 BTU Capacity -- The MECMER426H-15 is rated for up to 400,000 BTU/hr, making it suitable for high-demand applications including on-demand water heaters, furnaces, and full-system regulator feeds on larger RVs.

Compliance and Certifications

This pigtail hose meets the requirements of RVIA (Recreational Vehicle Industry Association) standards and NFPA 1192, the Standard on Recreational Vehicles. These certifications matter for insurance compliance, RV park entry, and ensuring your propane system was built to recognized safety codes.

100% Leak Tested: Every MECMER426H-15 hose is individually pressure-tested at the factory before packaging. Brass ferrules on each end provide secure, corrosion-resistant terminations at both the QCC fitting and the 1/4-inch MNPT outlet.

Installation Notes

  • Hand-tighten the QCC Type 1 nut onto the LP cylinder valve -- do not use a wrench on the QCC fitting.
  • Thread the 1/4-inch MNPT male end into the inlet port of your MEGR-253 or compatible regulator using appropriate thread sealant rated for LP gas service (not standard pipe dope).
  • After connection, perform a leak check using LP-rated leak detection solution on all fittings before opening the cylinder valve fully.
  • Route the hose to avoid sharp bends, contact with moving parts, and heat sources. The 15-inch length suits most standard RV propane compartment configurations.
  • Replace this hose if the thermoplastic body shows cracking, abrasion, or stiffening, or after any event that may have triggered the excess flow shutoff.
Maintenance Tip: Inspect the QCC nut and swivel fitting each season for cracking, debris, or cross-threading. The nylon QCC nut is designed for repeated hand-tightening but should be replaced if it no longer seats firmly or shows visible damage.
Excess Flow Activation: If the hose excess flow device trips (low flow/no flow at appliances after connecting), close the cylinder valve, disconnect from the appliance or regulator, wait 30 seconds, then reconnect and open the cylinder valve slowly. A rapid opening can re-trigger the device.

Product Specifications

ManufacturerMarshall Excelsior
Vendor Part NumberMECMER426H-15
SKU06-0043
UPC815505013697
Country of OriginMade in USA
WarrantyLimited 5-Year Manufacturer Warranty
Weight0.2 lbs

Hose Specifications

Hose Length15 inches
Hose Inside Diameter1/4 inch ID
Hose Body MaterialHigh-pressure thermoplastic
Ferrule MaterialBrass
Working Pressure350 PSIG
BTU Rating400,000 BTU/hr
Excess Flow Bypass Rate10 SCFH maximum
Heat Shutoff Range240 F -- 300 F (approx. 1/4" nipple displacement)

Connection Specifications

Cylinder-Side ConnectionFemale QCC (Quick Check Connector) Type 1, hand-tightenable swivel nut
Regulator-Side Connection1/4 inch MNPT (Male National Pipe Thread)
Tool RequirementNo wrench required at QCC end

Compatibility

Primary Regulator FitMarshall Excelsior MEGR-253, MEGR-253H (two-stage automatic changeover)
Cylinder Valve TypeStandard ACME-threaded LP cylinder valve (QCC Type 1)
ApplicationsMotorhomes, travel trailers, fifth wheels, on-demand LP water heaters

Compliance and Testing

Industry StandardsRVIA compliant, NFPA 1192 compliant
Leak Testing100% factory leak tested

Safety Features Summary

Excess Flow ShutoffYes -- automatic, resets on cylinder valve close/reopen
Heat-Sensitive DisplacementYes -- brass nipple displaces at 240-300 F to close cylinder valve module
Swivel QCC NutYes -- nylon swivel nut for hand-tight connection
Important Information -- Read Before Installing
  • This hose is designed for LP (liquefied petroleum / propane) gas service only. Do not use with natural gas systems.
  • The excess flow device inside the brass nipple can be triggered by opening the cylinder valve too quickly. Always open the cylinder valve slowly after making connections.
  • Do not use a wrench on the QCC Type 1 nylon swivel nut. Hand-tight is the correct installation torque. Over-tightening will damage the nut and fitting.
  • Use only LP-rated thread sealant (such as yellow PTFE tape for gas or LP-rated paste) on the 1/4-inch MNPT threads. Do not use standard plumber's pipe dope.
  • Inspect the hose before each camping season and before each extended use. Do not use a hose that shows cracking, abrasion, kinking, or damage to the ferrules or fittings.
  • The heat-sensitive shutoff is a single-event safety feature. If a high-heat event has occurred, inspect and replace the hose before returning the system to service.
  • This listing is for one (1) pigtail hose. A standard dual-cylinder setup requires two pigtails -- one per cylinder.
  • Not intended for underground, buried, or concealed in-wall installation.


Browse for more RV Accessories in the same category as this item:

LP Gas > LP Hoses
LP Gas