Home > LP Gas > LP Hoses >

Suburban 523005 Propane Pigtail Hose 1/4" ID x 12" Type 1 ACME Nut x 1/4" Inverted Male Flare

Suburban 523005 12-inch propane pigtail hose with Type 1 ACME nut and 1/4-inch inverted male flare connector for RV LP tank to regulator connection
Suburban Propane Hose, 1/4" ID Pigtail x Type 1 ACME Nut x 1/4" Inverted Male Flare, 12"
 
List Price: $26.09
: $18.89
You save $7.20!
Part Number: 523005
Manufacturer: Suburban Mfg

Quantity in Stock :40

Availability: In Stock
Qty:

 
Suburban MfgPart 523005Thermal ProtectedSuburban 523005 Propane Pigtail Hose -- 12" with Type 1 ACME Nut x 1/4" Inverted Male Flare

The Suburban 523005 is a 12-inch propane pigtail hose designed specifically to connect a portable or onboard LP cylinder to a two-stage regulator. With a Type 1 ACME nut on the tank end and a 1/4" inverted male flare on the regulator end, it delivers the correct fittings for standard RV and camper propane systems -- right out of the box, no adapters required.

Reliable LP Connection Between Tank and Regulator

Pigtail hoses like the Suburban 523005 are the short, flexible link between your propane cylinder and the inlet of a two-stage regulator. The pigtail design absorbs vibration and allows slight movement without stressing the regulator connection -- important in travel trailers, fifth wheels, and motorhomes where road vibration is constant.

The 12-inch length is the industry-standard pigtail length for most RV dual-cylinder setups. It provides enough slack to open and close the tank valve comfortably while keeping the hose routed neatly within a standard propane compartment.

Type 1 ACME Tank Fitting

Standard Type 1 ACME nut threads directly onto any DOT-approved Type 1 LP cylinder valve -- the same valve found on most 20 lb and 30 lb propane tanks used in RVs.

1/4" Inverted Male Flare Outlet

The regulator end uses a 1/4" inverted male flare, which mates with the standard inlet found on most two-stage RV propane regulators without additional adapters.

Thermal Protection

The hose includes thermal protection to guard against heat damage in confined propane compartments, extending service life in real-world RV conditions.

Compact 12" Pigtail Length

At 12 inches, this is the standard pigtail length for dual-cylinder RV regulator setups. Short enough to route cleanly, long enough to work comfortably at the tank valve.

Ready-to-Install Fitment

Both ends come fully assembled with the correct fittings for connecting a standard Type 1 LP cylinder directly to a two-stage RV regulator. No thread tape, adapters, or modification needed -- just hand-tighten the ACME nut and wrench-snug the flare fitting.

Typical Application: Dual-Cylinder RV Propane Systems

Most travel trailers and fifth wheels use two 20 lb or 30 lb propane cylinders with a two-stage regulator and an automatic or manual changeover. Each cylinder connects to the regulator via its own pigtail hose. The Suburban 523005 is the correct replacement or spare for this configuration. It is also used in single-cylinder setups where a two-stage regulator is mounted separately from the tank.

Hose Inspection and Replacement

Propane hoses should be inspected before each camping season and replaced if any cracking, brittleness, cuts, or scorch marks are present. A hose that passes a visual check should also be leak-tested with soapy water at every tank connection after installation. Do not use a hose showing any signs of damage.

Installation Tips
  • Hand-tighten the Type 1 ACME nut first -- over-torquing can damage the soft-seat valve. Standard practice is finger-tight plus a quarter turn with a wrench.
  • Snug the 1/4" inverted flare end to the regulator inlet with a wrench, but do not over-torque flare fittings or they will deform and leak.
  • After connecting, open the tank valve slowly and test all joints with soapy water or an approved leak detector solution before lighting any appliances.
  • Route the hose so it does not contact sharp edges or hot surfaces inside the propane compartment.

Product Specifications

ManufacturerSuburban Mfg
Part Number523005
UPC677917011827

Hose Dimensions

Hose Length12 inches
Inside Diameter1/4 inch
Weight0.1 lb

Fitting Details

Tank End FittingType 1 ACME nut (standard LP cylinder connection)
Regulator End Fitting1/4" inverted male flare
Compatible Tank ValveType 1 (OPD) -- standard on 20 lb and 30 lb DOT cylinders
Compatible Regulator InletTwo-stage regulators with 1/4" inverted flare inlet (standard RV)

Protection and Compliance

Thermal ProtectionYes -- included on hose body
WarrantyLimited 90-Day Manufacturer Warranty
Important Information
  • This hose is for use with LP (liquid petroleum / propane) gas systems only. Do not use with natural gas, compressed air, or other gases.
  • Inspect the hose for cracks, cuts, or deterioration before every use. Replace immediately if any damage is found.
  • Always perform a leak test with soapy water after installation and before operating any propane appliance.
  • Do not use in applications exceeding the rated working pressure for standard RV LP pigtail hoses (typically 250 PSI burst, 200 PSI working -- verify with Suburban documentation for your specific installation).
  • Keep away from open flame, sparks, and high-heat surfaces. Thermal protection reduces but does not eliminate heat risk.
  • Intended for RV and camping applications. Installation must comply with NFPA 58 (LP Gas Code) and all applicable local codes.
  • The ACME nut is a left-hand thread -- turn counterclockwise to tighten onto the tank valve (standard for all LP fittings).


Browse for more RV Accessories in the same category as this item:

LP Gas > LP Hoses
LP Gas


$30.95