Keep your 2x2 electric through-frame slide-out operating smoothly with this direct-replacement flush head assembly from Lippert. Designed to restore proper slide-out engagement and flush positioning, this adjustable assembly is a factory-matched replacement for Jayco and Keystone-built coaches equipped with the V-Tech through-frame slide-out system.
The Lippert V-Tech system is one of the most common electric through-frame slide-out platforms found in mid- to large-format travel trailers and fifth wheels. Over time, the flush head assembly -- the component that contacts the slide room wall and controls final flush positioning -- can wear, crack, or lose its adjustment range. This part restores that function with a direct OEM-equivalent replacement.
This assembly is specifically sized for the 2x2 (2-inch x 2-inch) tube configuration used in electric through-frame V-Tech applications. If your slide is not sitting flush, is showing light gaps at the seals, or the head is visibly damaged, this is the replacement part to order.
Built-in adjustment range lets you fine-tune slide room flush positioning without replacing the entire slide-out mechanism.
Matched to the 2-inch x 2-inch tube configuration of Lippert V-Tech electric through-frame slide-out systems.
Confirmed factory cross-reference numbers for Jayco (0323320) and Keystone RV (471712) make ordering straightforward.
Drop-in replacement for worn or damaged flush head assemblies -- no modifications required for compatible systems.
On a V-Tech through-frame slide-out, the flush head assembly mounts at the outboard end of the slide-out actuator tube and makes contact with the slide room wall to pull it into a flush, sealed position when the room is retracted. The adjustable design allows the installer or technician to dial in the exact contact pressure and final position so seals seat correctly and the room sits flat against the coach wall.
A worn or broken flush head commonly causes symptoms like light gaps around slide seals, uneven wall contact, or a slide room that does not retract fully flush. Replacing the assembly restores correct operation without requiring replacement of the entire actuator or slide mechanism.
The V-Tech through-frame slide-out system runs the actuator tube through the chassis frame rail rather than mounting entirely above or below it. This low-profile design is common in Jayco and Keystone travel trailers and fifth wheels built during the mid-2000s through the 2010s. If your slide uses a rectangular tube actuator that passes through the frame and is electrically driven, this part is likely compatible -- but verify using the OEM cross-reference numbers above or your coach's service manual parts list.
Match your existing part using one of the following: Lippert part number 181910, Jayco part number 0323320, or Keystone RV part number 471712. If your current flush head is stamped or labeled with any of these numbers, this assembly is a direct fit. You can also contact your coach manufacturer's parts department with your VIN to confirm.
Not all Lippert through-frame slide systems use the same flush head. Confirm your system is the V-Tech 2x2 electric variant before ordering. Lippert also produces hydraulic through-frame and cable-driven systems that use different hardware. When in doubt, photograph your existing assembly and compare before purchase.
When replacing the flush head assembly, inspect the actuator tube end and surrounding mounting hardware for corrosion or wear. Clean contact surfaces before installing the new head, and verify slide seal condition -- a new flush head will not compensate for collapsed or cracked slide seals.