Keep your toy hauler looking showroom-fresh between trips. The ADCO 01-0264 Designer Series SFS Aquashed cover is engineered specifically for toy hauler trailers and combines a triple-layer top panel with polypropylene side panels to shed water, resist UV damage, and maintain breathability -- so mold and mildew don't take hold while the rig sits.
Standard RV covers are cut for coaches and fifth wheels. Toy haulers have a distinct profile -- wider rear ramps, taller cargo doors, and heavier corner loads -- and ADCO's Designer Series is sized and reinforced to match. Part number 01-0264 (also referenced as ADCO 52276) covers trailers from 33 feet 7 inches up to 37 feet in overall length.
The multi-tone gray cover ships as a complete kit with everything needed for a clean, secure installation. Recommended for moderate climates and short-term storage applications.
30% more SFS Aquashed material than earlier ADCO covers. The triple-layer top panel beads water on contact and resists high humidity and rainfall more effectively than single-layer alternatives.
Triple-layer polypropylene sides allow moisture vapor to escape, preventing the trapped-humidity conditions that cause mold and mildew growth over weeks of storage.
Front and rear buckle cinching removes slack and keeps the cover tight against the trailer body. A bottom-mounted strap and buckle system prevents wind lift and flutter damage.
Zipper entry panels let you access your coach door, storage bays, or cargo ramp without removing the entire cover -- a real time-saver for seasonal or semi-permanent storage setups.
The top panel uses ADCO's SFS Aquashed composite -- a spun-bonded, film-laminated, spun-bonded structure that manages rain and humidity at the roof line, where water intrusion risk is highest. Side panels are triple-layer polypropylene, providing a balance of strength, breathability, and light weight. Reinforced front corners resist the snags and tears that typically develop first on covers as they flex in wind.
The outer layer of the SFS Aquashed top panel contains UV inhibitors that slow fabric degradation and protect the trailer's roof, decals, and sealants from direct sun exposure during storage. This is especially important for toy haulers stored outdoors between season-opening trips.
The cover is designed for one- or two-person installation. A weighted buckle toss-under system lets you feed the bottom straps under the coach without crawling on the ground. Rain gutter spout protectors slip over your trailer's drip rails to prevent the cover fabric from snagging or puncturing at those contact points. A ladder cap is included to pad ladder rungs and prevent them from wearing through the cover from the inside.
This cover (01-0264) fits toy haulers with an overall exterior length of 33 feet 7 inches to 37 feet. Measure your trailer's total exterior length -- bumper to hitch coupler -- before ordering. If your trailer falls near the bottom or top of this range and is unusually tall or wide, confirm the height (120 inches max) and width (106 inches max) specs below against your unit's measurements.
ADCO rates the Designer Series SFS Aquashed line for moderate climates and short-term storage. It is not rated for extreme winter conditions, heavy snow load, or sustained high winds. For full-season storage in harsh climates, ADCO offers heavier-duty lines (Tyvek, Polar White) that provide additional insulation and structural resistance.
This cover performs best in moderate-climate storage -- spring through fall, mild winters, or covered outdoor parking. It is not intended as a snow load or ice barrier. Remove accumulated debris from the cover surface periodically to reduce abrasion and extend cover life.