Purpose-built for unattended, long-term outdoor storage, the ADCO 01-2698 shields travel trailers from UV damage, wind-driven debris, and moisture while staying breathable enough to prevent mold and mildew from forming underneath. If your rig lives in a storage lot between trips, this cover is engineered for exactly that environment.
Most RV covers are designed for short-term driveway use. The ADCO Storage Lot series is different -- it uses a heavier 4-layer polypropylene construction on the sides and is UV treated throughout to handle months of unattended outdoor exposure without fading, cracking, or losing structural integrity.
The slip-seam CAM buckle strapping system pulls the cover tight at all four bottom corners and along the front and rear, eliminating the billowing and slapping that destroys lesser covers in windy conditions. Once set, the buckles hold without retightening.
Breathable, water-resistant side panels block UV rays and shed rain while allowing trapped moisture vapor to escape -- no condensation buildup under the cover.
Front, rear, and four-corner bottom buckles remove slack and lock the cover in position. No constant re-adjustment needed during extended storage.
Extra-heavy reinforcement patches at all eight corners -- top and bottom -- resist the abrasion and stress points where untreated covers snag and tear first.
Integrated vents let hot air escape from under the cover, reducing heat buildup and further protecting interior surfaces and roof seals during warm-weather storage.
By blocking UV rays, the cover slows the cracking and fading of sidewalls, graphics, and rubber roof membranes. It also keeps the roof surface clean, which directly reduces the black streaking that runs down trailer sides after rain -- cutting your pre-trip wash time significantly.
ADCO sizing is based on the overall trailer length measured from the two longest points -- including the rear bumper and any rear ladder, but excluding the hitch and coupler. This cover fits trailers measuring 24 ft 1 in to 26 ft by that measurement. If your trailer falls right at the boundary between two sizes, size up for easier installation and better coverage at the front cap.