Engineered specifically for unattended storage lot use, the ADCO 01-2696 protects your travel trailer from UV damage, moisture, wind-driven dirt, and roof streaking -- without trapping the moisture that causes mold and mildew. The 4-layer breathable polypropylene construction and cam buckle cinching system keep the cover locked down and performing season after season.
Most RV covers are designed for occasional weekend storage. The ADCO Storage Lot Cover series is built for extended, unattended use where you cannot check on your rig regularly. That means more robust corner reinforcements, a more secure strap system, and construction choices that hold up under prolonged sun exposure and wind loading.
The 4-layer polypropylene fabric works on two fronts: it sheds rain and resists UV rays on the outside, while allowing moisture vapor to pass through from the inside. That breathability is critical for preventing condensation buildup and the mold and mildew that follow. The tan colorway reflects rather than absorbs heat, helping keep interior temperatures lower during warm-weather storage.
Breathable, water-resistant fabric with UV inhibitors throughout the top and sides. Prevents cracking, fading, and black streaking on the roof.
Front, rear, and bottom cam buckles with a Slip-Seam Strapping System pull the cover tight at all 4 bottom corners, removing slack and eliminating billowing in wind.
Extra reinforcement material at all 8 corners -- top and bottom -- significantly reduces snags, tears, and wear at the highest-stress points of the cover.
Integrated vents allow air to circulate and escape, preventing pressure buildup and further reducing condensation under the cover during long storage periods.
Putting a large RV cover on solo is notoriously frustrating. ADCO addresses this with a weighted buckle toss-under strap -- you toss the weighted end under the trailer rather than crawling under it. Rain gutter spout protectors are included to keep the cover from being punctured where it contacts roof gutter spouts. Adhesive reinforcement patches are also included if any area shows wear over time.
ADCO sizes its storage lot covers by overall travel trailer length. Measure from the longest two points of your trailer, including rear bumper and rear ladder, but excluding the hitch. If your trailer measures anywhere from 20 ft 1 in up to 22 ft using this method, the 01-2696 is the correct size.