Purpose-built for unattended, long-term storage lot use, this ADCO cover wraps your travel trailer in a breathable, UV-treated 4-layer polypropylene shell. It locks down with a CAM buckle Slip-Seam strapping system, keeps moisture from trapping under the cover, and ships ready to install with every accessory you need to get it on and cinched tight.
Storage lots are tough environments. Trailers sit for weeks or months exposed to UV, wind, rain, and temperature swings -- all without anyone checking in. ADCO engineered this cover specifically for that scenario. The 4-layer polypropylene construction breathes, so moisture that gets under the cover can escape instead of turning into mold and mildew on your sidewalls and roof.
The Slip-Seam Strapping System pulls the cover snug at all four bottom corners, eliminating the billowing and flapping that shreds lesser covers in wind. CAM buckles hold the straps locked without slipping, so the cover stays put between visits.
Breathable, water-resistant sides allow vapor to escape while blocking rain and UV. Tan color on top and sides resists heat buildup.
Slip-Seam system cinches tight at all 4 bottom corners. CAM buckles lock straps in place and prevent loosening during unattended storage.
Extra reinforcement material at all 8 corners -- top and bottom -- reduces snags, tears, and wear at the highest-stress points on the cover.
Integrated vents allow air to circulate and escape, preventing pressure buildup that can cause ballooning in wind and moisture accumulation inside.
RV covers fall into two broad categories: driving/trailering covers and storage lot covers. ADCO's storage lot line -- including this 01-2701 -- is optimized for stationary, extended use. The materials prioritize breathability and long-term UV resistance over the aerodynamic concerns of a trailering cover. If your trailer lives in a paid lot or your driveway for months at a time, this is the correct cover category.
Keeping the roof covered is one of the best things you can do for a stored trailer. This cover shields the roof membrane from UV degradation, blocks the debris and dirt that causes black streaks to run down the sidewalls, and reduces how often you need to wash, wax, and treat the roof -- saving time and money at the start of each season.
Measure your trailer from the longest two points -- front to rear -- including the rear bumper and ladder, but excluding the hitch. If that measurement falls between 31 ft 7 in and 34 ft, this is your cover. If your trailer is shorter or longer, select the adjacent ADCO size to ensure a proper cinch fit. A cover that is too large will billow; one that is too small will not cinch and may stress the fabric.
ADCO offers storage lot covers for travel trailers ranging from under 20 ft to over 40 ft. Each size is a distinct SKU. If your trailer is outside the 31 ft 7 in to 34 ft window, check the adjacent ADCO sizes for the correct fit. All sizes use the same 4-layer polypropylene material and Slip-Seam strapping system.