Direct replacement vent lid for Ventline roof vents manufactured 2008 and later. Black polypropylene. Impact-resistant. Reinforced center bar. Pre-assembled — mounting hardware included. Fits all 14"×14" vents.
This vent lid is specifically designed for Ventline vents manufactured 2008 and later. It is not a replacement for pre-2008 Ventline vents or Elixir vents. If your Ventline vent was manufactured before 2008, or if you have an Elixir vent, see the Camco 40177 or 40178 instead. Confirm your vent brand and manufacture year before ordering — the mounting design changed with Ventline's 2008 redesign and the lids are not interchangeable.
The Camco 40176 is the correct replacement vent lid for Ventline roof vents from 2008 onward — not the same design as pre-2008 Ventline or Elixir lids. Ventline revised their vent design in 2008 and the lid profile, hinge mount, and dimensions changed. Ordering the wrong era lid is the most common mistake buyers make with Ventline replacement lids.
Black polypropylene construction with a reinforced center bar arrives pre-assembled with all mounting hardware. A broken or cracked vent lid is one of the most direct causes of RV roof leaks — a quick, correct-fit replacement restores the weatherproof seal.
Matches the revised lid profile and hinge design of Ventline vents manufactured 2008 and later — not interchangeable with pre-2008 lids
Black polypropylene construction withstands rooftop impact and weather exposure as a durable direct replacement
Structural center bar adds rigidity — prevents flexing and cracking under wind load
Arrives ready to install with all mounting hardware — no additional parts or sourcing needed
Covered by a 90-day limited manufacturer warranty against defects in materials and workmanship.
• (1) Camco 40176 Black Replacement Vent Lid (pre-assembled) • Mounting hardware
Verify compatibility first: Confirm your Ventline vent was manufactured 2008 or later before installing. Pre-assembled: The lid arrives fully assembled — no prep work needed. Hardware included: All mounting screws and hardware are in the box. Inspect the vent hinge and frame before installing the new lid. If the hinge or base frame is damaged, the lid may not seal correctly even with the correct replacement part.
Ventline 2008 and later → 40176 (this product) Ventline pre-2008 → 40177 (polypropylene) or 40178 (polycarbonate) Elixir after 1994 → 40177 (polypropylene) or 40178 (polycarbonate) The 2008 Ventline redesign changed the lid dimensions and hinge mount — lids from each era are not interchangeable.