The factory-matched interior ceiling assembly for Coleman Mach heat pump rooftop units. This Deluxe-style non-ducted assembly handles both cooling and heat pump operation, letting you replace a worn or damaged ceiling box without swapping out your entire rooftop unit.
The ceiling assembly is the indoor-facing component of your rooftop air conditioner. It houses the evaporator coil, blower motor, controls interface, and the return-air/supply-air grille that you see from inside your RV. When this unit fails -- or when you're upgrading from a cooling-only ceiling box to a heat-ready one -- replacing just the ceiling assembly is far more economical than replacing the entire rooftop unit.
Part number 9630A715 is the Deluxe-style, non-ducted, heat-ready variant. "Heat-ready" means it is wired and configured to work with a compatible Coleman Mach heat pump rooftop unit; it will not add heat pump capability to a standard cooling-only rooftop unit. "Non-ducted" means conditioned air is delivered directly into the RV living space through the ceiling grille rather than through a duct distribution system.
Pre-wired and configured to operate with Coleman Mach heat pump rooftop units for both heating and cooling modes.
Delivers conditioned air directly into the RV cabin through the integrated grille -- no duct distribution system required.
Low-profile white finish blends with most RV interior ceilings and matches OEM Coleman Mach aesthetics.
Designed to mount directly to the standard Coleman Mach ceiling cutout -- no modification to the rooftop unit or ceiling opening typically required.
This listing is for the ceiling assembly only. The rooftop condensing unit, power cord, thermostat, and any remote control are sold separately. Verify that your existing rooftop unit is a heat pump model before ordering; installing a heat-ready ceiling assembly on a cooling-only rooftop unit will not add heat pump functionality.
Manufacturer part number CMN9630A715 (vendor/OEM), product code 64522. UPC 755790202843. Sourced directly from the Coleman Mach product line to ensure fit and finish match your existing rooftop unit.
Non-ducted systems (sometimes called "free-blow") push air directly through the ceiling grille into one zone. They are the most common configuration in Class A, Class C, and fifth-wheel RVs where a single AC unit serves the main living area. Ducted systems route conditioned air through a plenum and duct network to multiple registers throughout the coach.
If your existing ceiling box has a single large grille and no duct connections on the sides, you have a non-ducted system and this assembly is the correct type. If your ceiling box has duct collars or plenum connections, you need the ducted variant instead.
Coleman Mach ceiling assemblies are matched to specific rooftop unit families by BTU rating, voltage configuration, and control board type. Cross-reference your rooftop unit's model number with Coleman Mach's compatibility guide or contact RV Upgrade Store to confirm this 9630A715 assembly is correct for your specific unit before installation.
Replacement ceiling assemblies mount to the four-bolt pattern on the ceiling mounting ring that is shared with the rooftop unit. Typical installation steps:
RV rooftop air conditioners operate on 120V AC power. Always disconnect shore power and turn off the AC breaker before beginning any ceiling assembly work. Verify wiring connections match the original harness configuration before restoring power.
After installation, clean or replace the ceiling assembly air filter before first use. Inspect the foam gasket between the rooftop unit and the ceiling assembly annually -- a deteriorated gasket allows warm humid air into the ceiling cavity, reducing efficiency and potentially causing condensation damage. Coleman Mach replacement gaskets and filters are available separately.