The Lippert 349521 is the factory-matched replacement nozzle for Waste Master sewer hoses. It snaps directly onto the clear-view fitting of your existing Waste Master hose assembly, adds a lever-operated shut-off valve so you control the flow, and redirects waste at a 90-degree angle to seat cleanly in any standard campground or dump station inlet. If your current nozzle is cracked, leaking, or missing, this is the correct OEM-spec replacement -- no improvising with generic fittings that don't seal properly on the Waste Master bayonet system.
Waste Master sewer hoses use a proprietary bayonet-style clear-view fitting that is not compatible with standard RV sewer nozzles. The 349521 is engineered specifically for that interface. Installation requires a 1/8" punch and hammer to drive the included dowel pins -- a straightforward job that permanently locks the nozzle to the hose end and prevents blowoff under flow pressure.
The molded construction is rigid enough to hold the 90-degree discharge angle steady while you connect to a dump inlet, and the easy-grip handle gives you positive one-hand control without bending down awkwardly. The included end seal and Dow Corning 111 lubricant ensure a leak-free fit from the first use.
Lever-operated valve lets you open and close flow without removing the nozzle from the dump inlet -- cleaner and safer than pulling the hose.
Angled outlet drops straight into standard campground sewer inlets and dump station ports without awkward hose positioning.
Attaches directly to the clear-view fitting on your Waste Master hose. Not compatible with Rhino Flex, Camco, or other brand hose ends.
Comes with two dowel pins, one end seal, and Dow Corning 111 lubricant -- everything needed for a permanent, leak-free installation.
This is the correct Lippert factory part for Waste Master hose assemblies. Using a generic nozzle on the Waste Master bayonet fitting risks blowoff or sewage leaks at the connection point. The 349521 is the only nozzle designed to lock securely onto this system.
Installation requires a 1/8" punch and hammer to seat the two included dowel pins through the nozzle collar and into the clear-view fitting body. This is a permanent installation -- the nozzle is not designed to be removed and reused on a different hose. No adhesives or thread sealants are required.
This nozzle is the correct service part for the Lippert Waste Master 20-foot and 23-foot sewer hose kits. If your hose body is still in good condition but the nozzle is damaged, the 349521 restores full function without replacing the entire hose assembly.