A full 12 feet of UL/CSA-approved propane supply hose built to OEM standards. Designed for routing LP gas from the regulator or distribution block to appliances inside your RV, this hose features 3/8" female swivel SAE flare fittings on both ends for leak-free connections without special tools or adapters.
When your factory propane hose cracks, stiffens, or shows signs of age, a like-for-like OEM-spec replacement is the safest choice. JR Products engineers these hoses to match the original routing lengths and fitting standards used by major RV manufacturers, so you spend less time modifying and more time on the road.
At 144 inches (12 feet), this hose covers appliance runs that shorter hoses cannot reach -- ideal for furnaces, water heaters, ranges, and refrigerators positioned farther from the LP distribution point. The swivel ends simplify installation by rotating to meet the fitting angle without twisting the hose body.
Both ends use 3/8" female swivel SAE flare connections. The swivel design lets you torque the fitting to the appliance or regulator without twisting or kinking the hose body.
144" (12 ft) overall length matches common factory routing runs in Class A, Class C, and fifth-wheel floorplans where appliances are separated from the LP supply manifold by significant distance.
Listed to UL and CSA standards for LP gas service. Meets the same certification requirements as original equipment hoses installed by the RV manufacturer.
1/4" ID rubber hose is flexible enough for tight routing paths and resistant to the temperature swings common in RV chassis and cabinetry environments.
Both fittings are 3/8" female swivel SAE flare. Before ordering, verify your appliance inlet and regulator/distribution block outlet are also 3/8" SAE flare male. If your system uses POL, ACME, or NPT fittings, adapter fittings will be required.
When routing the hose, avoid sharp bends tighter than the hose's natural bend radius and keep the hose away from direct contact with exhaust components or other heat sources. Use approved LP clamps or grommets wherever the hose passes through a bulkhead or floor.
No additional fittings, adapters, clamps, or sealant tape is included. Verify fitting compatibility with your appliance and supply manifold before installation.