Replacement HappiJac rear tie-down anchor built for truck camper anchor tie-down systems. Rotates to the direction of pull to eliminate leverage and stress on the truck, keeping your camper securely tied down at the rear.
The Lippert 182866 is a replacement HappiJac universal rear anchor tie-down for your truck camper tie-down system. Its removable rear tie-down coupler rotates to the direction of pull, eliminating undesirable torque and stress forces on the truck.
This anchor is part of the Camper Anchor Tie-Down series, engineered with an I-beam truss structure that combines frame strength with sound engineering principles to make your camper an integral, securely tied-down part of the truck.
Rotates to direction of pull, eliminating leverage and torque
I-beam truss design resists bending, twisting, and failure
Durable, bed-mount steel anchor built for repeated use
Fits a range of truck models across multiple manufacturers
Per Lippert's official product listing, the 182866 is a HappiJac Universal Rear Tiedown (Camper Anchor Tie-Down series, reference CA-UR) — a bed-mount anchor used to tie down a truck camper. It is not listed as a slide-out anchor or general RV stabilizer. If you're looking for a slide-out anchor or a stabilizer jack component, this is not the correct part — confirm the specific part number with Lippert before ordering.
This anchor is compatible with: 1973–2011 S-10, S-15, Chevy/GMC Canyon & Colorado; 2013 and earlier Ford Ranger; 1989–2018 Toyota (campers under 1,500 lbs., except Tundra); 1989–2008 Isuzu; 1994–2008 Mazda; and 1998–2018 Nissan (campers under 1,500 lbs.). Quantity four (4) required for a complete installation. Not intended for full-size extended cab, crew cab, 4x4, or diesel trucks, or campers over 2,500 lbs. — those applications require HappiJac Frame Mount tie-downs instead.
General Installation Steps: 1. Choose Anchor Position: Select a position as far from the front edge of the bumper as possible 2. Drill Pilot Hole: Punch a 1/8" pilot hole, then expand to 1/2" 3. Mount the Anchor: Secure using 2" mudguard washers, lock washers, and nuts 4. Repeat for All Anchors: Install a total of four (4) anchors as required 5. Test Fit: Confirm the coupler rotates freely to the direction of pull
In The Box: • One (1) Rear Tie-Down Anchor with Rotating Coupler Not Included: • Mounting Hardware (washers, lock washers, nuts) • Additional anchors (4 total required per installation)