The factory-correct replacement harness that restores communication between your Lippert leveling touchpad and control module. Plug-and-play fit, 10 ft of routable length, and no splicing required in most installations.
When a leveling touchpad goes dark or stops responding, the problem is often the interface harness -- not the touchpad or control module itself. A pinched, corroded, or cut 4-pin cable kills communication between the two components and leaves the system unable to receive commands. Lippert part 241316 is the direct OEM-style replacement that gets the system talking again.
The 10 ft length gives you enough slack to route the cable cleanly through cabinetry, walls, and storage bays without needing extensions or butt-splice repairs that introduce new failure points. Both ends terminate in Lippert's keyed 4-pin connectors -- just unplug the old harness and plug in the new one.
Pre-terminated 4-pin connectors on both ends match Lippert leveling system wiring. No splicing or pin crimping needed in most standard installs.
Enough cable to route cleanly from the control module in a basement bay up through a wall to a touchpad mounted inside the RV -- without pulling tight around corners.
Specifically designed for use between Lippert control module 242623-4 and touchpad 421484. Verify your connector style before ordering.
Replaces damaged, corroded, or kinked cables that cause the touchpad to lock up, display errors, or respond inconsistently to leveling commands.
This is a straightforward swap in most rigs. Follow these steps for a clean install:
If the touchpad still does not respond after installing a new harness, work through these checks before assuming the control module or touchpad is faulty:
Yes. Lippert 241316 is the 10 ft 4-pin interface harness specified for that control module-to-touchpad connection.
Yes. If your original cable was shorter and you need more routing flexibility, the 10 ft length of part 241316 can replace it. Coil and secure any excess slack rather than cutting the cable.
No. Lippert has used multiple harness styles across different leveling system generations. This harness is specifically for 4-pin connector systems. Inspect your existing connector before ordering -- if it is a 6-pin or 8-pin connector, you need a different part number.