Stop the sway and rock in your travel trailer or fifth wheel with the Lippert 285332 Stabilizing Scissor Jack. A heavy-duty steel unit rated at 6000 lbs, it extends to 30 inches and collapses to just 4-1/4 inches for a low-profile fit under virtually any RV frame rail. Bolt it on with the included hardware or weld it permanently -- either way it installs in under an hour and delivers solid, reliable corner stabilization every time you set camp.
The Lippert 285332 is a single scissor jack designed for manual operation -- no electric motor, no hydraulics, no special tools required beyond a standard 7/8-inch socket or a cordless drill with the right bit. Crank it down, contact the ground, and you eliminate the frame flex and corner bounce that makes life miserable in a parked rig.
The bow-tie shaped base plate distributes load across a wider footprint than a standard flat pad, keeping the jack from sinking into soft ground like grass, gravel, or compacted dirt. That matters when you are camping off-pavement and need confidence in your footing.
Extends from a collapsed height of 4-1/4 in. to a full 30 in., accommodating a wide range of frame heights and uneven terrain without shimming or stacking pads.
Rated at 6000 lbs per jack, providing substantial stabilizing force for travel trailers, fifth wheels, and toy haulers up to the frame's rated capacity.
Wider footprint at each end of the base plate distributes load and resists tipping or sinking on soft ground -- no separate foot pad required on most surfaces.
Universal mounting works either way. Mounting hardware is included for a bolt-on install. Welding directly to the frame is also an option for a permanent, tool-free-removal setup.
The 285332 is built from heavy-duty steel throughout -- arms, pivot pins, and base. A powder-coated finish provides rust resistance against road salt, rain, and ground moisture. At 18 lbs per jack, it is substantial enough to feel solid underfoot during installation but light enough to handle without assistance.
Most owners bolt the 285332 to existing crossmember or frame flanges using the included mounting hardware. If you are doing a frame-up build, adding a replacement jack to a custom trailer, or just want a permanent installation, welding is equally supported. The mounting bracket geometry is compatible with standard RV frame rail widths common on travel trailers and fifth wheels.
This is a manual scissor jack operated by a 7/8-inch socket, T-handle, or cordless drill with a compatible socket adapter. There is no 12V motor, no wiring, and no controller needed. That makes it ideal as a replacement for failed power jacks, as an add-on stabilizer in corners without existing jacks, or for rigs where keeping the system simple is a priority.