OEM base roller assembly for BAL Accu-Slide ABS, Accu-Slide ECONO, and Exact-Slide slide-out systems. 1.75" x 4.57" white nylon roller. Requires room to be pulled for installation. For field-serviceable replacement without pulling the room, see BAL 22324.
The BAL 854275 is the OEM floor roller base assembly used across BAL's Accu-Slide ABS, Accu-Slide ECONO, and Exact-Slide slide-out systems. It is the white nylon roller assembly that supports the base of the slide-out room, allowing the room to extend and retract smoothly on the floor track. The roller sits in the base of the slide-out mechanism and bears the vertical load of the room floor as it travels in and out.
This is the original-equipment roller that ships installed in new BAL slide-out systems. When worn or damaged, it is replaced as a complete base assembly. BAL's own product note is important: the 854275 requires the slide-out room to be fully pulled (removed) for installation. If pulling the room is not practical in the field, BAL offers the 22324 Roller Assembly as the service-friendly alternative — it is specifically designed for 1.00" height roller replacement without pulling the room.
Per BAL's own product page: the 854275 requires the slide-out room to be fully pulled (removed) for installation. This is a shop-level service procedure and is not practical as a field repair. If the room cannot be pulled: Use BAL 22324 instead — it is the roller assembly specifically designed for 1.00" height roller replacement without pulling the room, and is BAL's recommended field-serviceable alternative.
854275 — Floor Roller Base Assembly, white nylon, 1.75" x 4.57" (this item — requires room pull) 22324 — Roller Assembly for 1.00" height roller — field serviceable, no room pull required 854303 — Replacement Base Roller for 3/4" wear bar — aftermarket roller to assist collapsed 3/4" wear bar 854304 — Replacement Base Roller for 1/2" wear bar — aftermarket roller to assist collapsed 1/2" wear bar Note: The 854303 and 854304 are aftermarket assist rollers used when the original wear bar has collapsed — they do not replace the 854275 base assembly.
• 1x BAL 854275 Floor Roller Base Assembly Service Note from BAL: BAL recommends that service providers and dealers obtain parts through their distributor for stock inventory and warranty replacement. Direct ordering through BAL's website is offered as an alternative source for individual parts on a case-by-case basis.