Universal recycled rubber base extender for compatible 12"–12.5" leveling buckets and 8-1/2" plastic stacker blocks, adding grip, stability, protection, and extra height during RV setup.
The SnapPad BASE1, also known as The Base, is a universal rubber add-on designed to improve the stability and durability of compatible RV leveling buckets and plastic stacker block setups. It helps create a more secure contact surface between the leveling block and the ground.
Unlike traditional SnapPads that attach to a specific RV jack foot, this base extender works with compatible leveling buckets and stacker blocks. It is made from rugged recycled rubber and helps add grip, reduce movement, protect plastic levelers, and provide extra height during campsite setup.
Designed for compatible leveling buckets and plastic stacker blocks
Made from rugged recycled rubber for outdoor leveling support
Adds approximately 3/4" of usable height to a stacker setup
Compatible with many RV types when used with supported buckets or blocks
SnapPad BASE1 is not a permanent snap-on jack foot pad and should not be selected by RV make/model or jack foot size alone. It is intended as a base extender for compatible leveling buckets and stacker blocks. Compatible stackers include Andersen Hitches® Trailer Jack Block bucket, Stromberg Carlson® 12" diameter Base Pad Extreme, and standard 8-1/2" x 8-1/2" plastic stacker blocks.
Before Starting: Confirm the leveling bucket or stacker block size before use. Place the base on stable ground and inspect the setup for cracks, damage, or unstable surfaces. Basic Use Steps: 1. Confirm Compatibility: Verify that the leveling bucket or stacker block fits the BASE1 size range. 2. Choose Stable Ground: Place the Base on firm, level ground whenever possible. 3. Position the Leveler: Place the compatible bucket or stacker block into/on the Base according to the leveler style. 4. Align the Jack or Tire Support: Make sure the jack foot, leveling bucket, or stacker setup is centered and stable. 5. Apply Load Slowly: Lower the jack or position the leveling setup gradually while checking for movement. 6. Confirm Stability: Make sure the Base, bucket/block, and jack or support point remain flat and secure. 7. Inspect After Use: Check for damage, debris, mud, or wear before storing or reusing.
Package Contents: • 1 SnapPad BASE1 universal base extender NOT Included — May Also Need: • Leveling bucket • Plastic stacker blocks • RV jack pad or jack foot • Wheel chocks • Additional BASE1 units for multiple support points This listing is for one SnapPad BASE1 base extender only. Leveling buckets, stacker blocks, jacks, and chocks are sold separately unless otherwise stated.
To confirm compatibility before ordering, have the following ready: • Leveling bucket diameter • Stacker block dimensions • Brand/model of leveling bucket or stacker block, if known • Photos of the leveling bucket or stacker block being used • Number of support points needing a base extender • Type of campsite surfaces commonly used: gravel, dirt, grass, concrete, or asphalt Why this matters: SnapPad BASE1 is matched to the leveling bucket or block, not directly to the RV jack foot. Regular SnapPad jack pads are selected by jack foot size and shape, while BASE1 is selected by the bucket or stacker block size.
Match SnapPad BASE1 by leveling bucket or stacker block size. This product is not the same as a permanent SnapPad selected by RV jack foot shape and size.
If the leveling setup still shifts, sinks, or feels unstable, check ground condition, jack placement, bucket/block condition, wheel chocking, and overall RV leveling procedure before adding more height.