When a worn or damaged clevis pin sidelines your RV entry steps, this genuine Lippert replacement gets your SolidStep 2.0 assembly back in service fast. This is the correct OEM pin -- not a generic substitute -- so fit and function match the original design without any guesswork or modification.
The clevis pin is a small but critical piece of hardware in the SolidStep 2.0 linkage system. It connects pivot and hinge points in the step mechanism, allowing the steps to fold, extend, and lock correctly. A bent, corroded, or missing pin causes the steps to bind, fail to deploy, or become unsafe to use.
Lippert part number 645114 (also referenced as SKU 15-9374) is the factory-correct replacement for this pin. Using the genuine Lippert part ensures the proper diameter, length, and material spec so the pin seats and retains correctly within the step assembly hardware.
Designed specifically for SolidStep 2.0 step assemblies -- no drilling, grinding, or adapter needed for a correct fit.
Weighs just 0.05 lbs, so it adds virtually no mass to the step assembly while restoring full mechanical function.
Direct OEM replacement means installation requires only basic hand tools. No special alignment or calibration needed.
Backed by Lippert's limited 1-year manufacturer warranty for added peace of mind on the repair.
Road vibration, moisture, and repeated cycling can cause clevis pins to wear grooves, corrode, or work loose over time. If your SolidStep 2.0 steps feel sloppy, refuse to fully extend, or make a clunking sound during deployment, inspect all clevis pins in the linkage first -- they are often the lowest-cost fix before replacing larger step components.
SolidStep 2.0 is Lippert's retractable entry step system found on a wide range of travel trailers, fifth wheels, and motorhomes. The 2.0 designation indicates the second-generation design with improved linkage geometry and step surface. This clevis pin (645114) is specific to the 2.0 generation -- confirm your step model before ordering if you are unsure which generation is installed on your rig.
This pin is designed for SolidStep 2.0 assemblies. If your coach has original SolidStep (first-generation) hardware, verify the correct part number with Lippert before purchasing, as pin dimensions may differ between generations.
When replacing the clevis pin, inspect the cotter pin or retaining clip at the same time. These small retainers are what keep the clevis pin from walking out during operation. Replace any worn or missing retainers to prevent premature failure of the new pin.