Protect your truck camper from rain, humidity, UV damage, and wind with the ADCO SFS AquaShed cover sized for campers from 8 to 10 feet in length with queen-size sleeping arrangements. The triple-layer AquaShed top sheds water on contact while breathable polypropylene side panels keep air moving to prevent mold and mildew buildup during seasonal or short-term storage.
The ADCO AquaShed system is built for owners who store their camper in wet, humid, or rain-heavy environments. The top panel uses a three-layer SFS (Spunbond-Film-Spunbond) laminate that actively beads water away from the surface while still allowing vapor to escape from beneath. This matters in practice: condensation that builds up inside a non-breathable cover is a primary cause of wood rot, mildew staining, and musty odors after winter storage.
Side panels are constructed from high-performance polypropylene -- 100% breathable and resistant to the mold and mildew growth that plagues cheaper solid-film covers. ADCO rates this cover ideal for moderate climates and short-term to seasonal storage. If you are in an extreme UV environment year-round (desert Southwest), consider ADCO's Designer or SFS AquaShed Max line for heavier UV blocking.
Spunbond-Film-Spunbond laminate beads water instantly and resists UV degradation on the roof and upper panels where sun and rain hit hardest.
100% polypropylene sides allow moisture vapor to escape, virtually eliminating mold and mildew growth on walls and interior surfaces during storage.
Full-height rear zipper door lets you access the camper interior without removing the entire cover -- useful for retrieving gear mid-storage season.
Strap and buckle attachments prevent billowing in wind. Elasticized and reinforced corners resist tears and snags. Front and rear cinching pulls out loose fabric for a tailored appearance.
Most entry-level RV covers use a single layer of woven polypropylene across the entire surface. This material breathes reasonably well but offers minimal water resistance -- rain eventually wicks through seams and stitching. ADCO engineered the AquaShed top panel specifically to address this: the film core of the SFS laminate stops liquid water while the outer and inner spunbond layers provide structure and abrasion resistance. ADCO claims roughly triple the moisture protection of a standard single-layer cover on the top surface.
Measuring a truck camper correctly is critical. ADCO instructs you to measure the full external length including the bumper, rear ladder, and any spare tire mounted at the rear. Do not measure only the camper box itself. The 8 ft to 10 ft size designation refers to this full measured length.
Two people make installation significantly easier on a tall truck camper. Work the cover over the nose first, then walk it back toward the rear, pulling the side panels down evenly. Engage the buckle straps from front to rear to snug the fit before cinching. Check strap tension after the first wind event -- straps may need minor adjustment after initial settling.