Stop wrestling with a manual crank every time you hitch or unhitch. The Stromberg Carlson JET-3755 electric tongue jack gives you push-button leveling and hitching on travel trailers and A-frame tongue trailers, with a 3500 lb rated lift capacity and a rugged black powder coat finish that holds up to road grime, weather, and UV exposure mile after mile.
Hitching and unhitching your trailer is a regular part of RV life, but cranking a manual tongue jack -- especially on an uneven driveway or in the rain -- gets old fast. The JET-3755 replaces your manual jack with a 12V DC electric motor that raises and lowers your trailer tongue smoothly and quickly using a simple rocker switch wired directly to your tow vehicle or trailer battery.
The black powder coat finish blends cleanly with most dark-colored trailer frames and A-frames, and resists corrosion better than bare steel. At 26 lbs the jack is substantial enough for demanding duty while still being manageable for a single-person install.
Rated for up to 3500 lbs tongue weight -- handles most travel trailers and lightweight fifth-wheel setups without straining the motor.
Wires directly to your trailer's 12V battery or tow vehicle auxiliary circuit. No inverter required, no extension cords, no hand-cranking.
Durable black coating resists rust, UV fade, and road debris. Matches most dark-frame trailers for a clean factory look.
Integrated drop foot (A-frame foot) extends travel range and provides a stable, wide base on gravel, asphalt, and dirt pads.
Stromberg Carlson's JET series electric tongue jacks are designed as direct-bolt replacements for worn or undersized manual tongue jacks on travel trailers, pop-ups with steel tongue frames, and lightweight fifth-wheel hitches with A-frame tongues. The JET-3755 is the standard-capacity black-finish variant in the series, paired alongside chrome-finish and heavier-duty higher-capacity models for owners who need more lift rating or a specific appearance.
If you are currently running a manual crank tongue jack in the 2000-3500 lb class on a standard tube-frame A-tongue, the JET-3755 is the intended upgrade path. It mounts using the same bolt pattern as most OEM manual jacks, making the swap straightforward for a DIY installer with basic hand tools.
The jack ships at 36 inches overall length, which accounts for the full retracted height of the unit including motor housing and drop foot. Measure your existing tongue jack mounting location before ordering -- verify tube diameter or mounting bracket spacing matches the JET-3755's mounting hardware. Most standard A-frame tongue tubes accept U-bolt mounting in the 2-inch to 3-inch tube OD range.
The unit weighs 26 lbs and has an overall packaged footprint of 36 x 10 x 10 inches, so plan for a helper when positioning it during installation -- holding the jack in alignment while threading mounting hardware solo is awkward.